molecalculator

Moles & Molar Mass

Acid Base Normal Values: pH, PaCO₂ and HCO₃⁻

Calculator No. 01-2425 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Typical adult arterial blood gas reference values are pH 7.35–7.45, PaCO₂ 35–45 mmHg, bicarbonate (HCO₃⁻) 22–26 mmol/L, and PaO₂ about 80–100 mmHg at sea level. This calculator checks whether entered pH, PaCO₂ and bicarbonate values fall within those commonly used ranges; it reports the individual results, not a diagnosis.

Formula

The usual reference intervals are compared directly: pH 7.35–7.45 (unitless), arterial carbon dioxide partial pressure PaCO₂ 35–45 mmHg, and bicarbonate HCO₃⁻ 22–26 mmol/L. The conventional Henderson–Hasselbalch relationship for blood is pH = 6.1 + log₁₀(HCO₃⁻ / (0.03 × PaCO₂)), with HCO₃⁻ in mmol/L and PaCO₂ in mmHg. The calculator block is a range check for each entered value, not a solver of this equation or an interpretation of a blood sample. Its status outputs are intended to show whether the entered number is within the stated interval; an output of 1 means within range and 0 means outside it.

Worked Example

Using the block’s default values, pH is 7.40, PaCO₂ is 40 mmHg, and bicarbonate is 24 mmol/L. Compare each with its reference interval:

  • pH: 7.35 ≤ 7.40 ≤ 7.45, so it is within the stated interval.
  • PaCO₂: 35 ≤ 40 ≤ 45 mmHg, so it is within the stated interval.
  • HCO₃⁻: 22 ≤ 24 ≤ 26 mmol/L, so it is within the stated interval.

For context, the Henderson–Hasselbalch calculation gives pH = 6.1 + log₁₀(24 / (0.03 × 40)) = 6.1 + log₁₀(20) ≈ 7.4010, which rounds to 7.40. That agreement is illustrative: measured pH and calculated bicarbonate in an actual blood gas are related, and reported values may differ slightly because of rounding and measurement methods.

Assumptions

  • The reference intervals are common adult arterial blood gas ranges, not universal laboratory cutoffs.
  • PaCO₂ and pH refer to an arterial sample; venous values are not interchangeable with arterial values.
  • The calculator checks values independently and does not assess symptoms, cause, compensation or clinical urgency.

What “Normal” Acid–Base Values Mean

Acid–base status describes the balance that keeps blood pH within a narrow range. The pH scale is logarithmic: a change of 0.1 pH unit represents a substantial change in hydrogen-ion concentration, even if the number looks small. In routine blood gas interpretation, pH below 7.35 is called acidemia and pH above 7.45 is called alkalemia. Acidosis and alkalosis name processes that push pH in those directions; the terms do not necessarily mean the measured pH is outside range, because more than one process can be present.

PaCO₂ reflects the respiratory component: carbon dioxide dissolved in blood behaves as an acid contributor. Bicarbonate is the main measured metabolic component and acts as a buffer. The kidneys regulate bicarbonate over a longer period, while breathing can alter carbon dioxide more quickly. Together, these values help describe the pattern, but they must be interpreted alongside the clinical setting and other laboratory findings.

How to Interpret the Pattern

A value outside its interval is a clue, not a complete conclusion. First identify whether pH indicates acidemia or alkalemia, then examine PaCO₂ and bicarbonate to see which change could explain that direction. A high PaCO₂ tends to lower pH; a low PaCO₂ tends to raise it. A low bicarbonate tends to lower pH; a high bicarbonate tends to raise it. When both components are abnormal, compensation or a mixed disorder may be involved.

  • Low pH with high PaCO₂ suggests a respiratory acidifying process.
  • Low pH with low bicarbonate suggests a metabolic acidifying process.
  • High pH with low PaCO₂ suggests a respiratory alkalinizing process.
  • High pH with high bicarbonate suggests a metabolic alkalinizing process.

These are starting patterns only. Compensation can move the other variable, and simultaneous disorders can obscure the expected pattern. A normal pH does not rule out an acid–base disorder: opposing processes may bring the measured pH into the reference interval while PaCO₂ and bicarbonate remain abnormal.

Reference Ranges and Important Differences

Intervals vary by laboratory, analyzer, age, altitude, sample type and clinical context. PaO₂, the partial pressure of oxygen, is often around 80–100 mmHg in a healthy adult breathing room air at sea level, but it changes with age, elevation, inspired oxygen and lung function. Oxygen saturation and PaO₂ are related but are not the same measurement. Use the interval printed on the laboratory report for a specific result rather than substituting a general range.

Arterial and venous blood gas results have different expected values. Venous pH is usually slightly lower and venous PCO₂ somewhat higher than arterial values, but the difference is variable and venous oxygen pressure does not stand in for arterial oxygenation. Do not compare a venous result with an arterial reference interval as if they were equivalent.

Common Mistakes and Limits

  • Treating the range as a diagnosis: one abnormal result cannot identify the cause or severity on its own.
  • Assuming normal pH means normal acid–base status: mixed processes may offset one another.
  • Mixing units: PaCO₂ ranges quoted here use mmHg. Some reports use kPa; convert before comparing (1 kPa ≈ 7.5006 mmHg).
  • Ignoring sample conditions: delays, air exposure, collection technique and sample type can affect results.
  • Overinterpreting calculator output: this page performs simple comparisons and does not calculate expected compensation or evaluate oxygenation.

Blood gas results should be considered with symptoms, examination, chemistry results and the laboratory’s own reference intervals. If a result is unexpected, interpretation belongs with a qualified health professional; severe symptoms or a rapidly worsening condition call for urgent medical assessment.

Frequently Asked Questions

What is the normal pH range for blood?
Common adult arterial blood pH values are 7.35–7.45. The laboratory’s reported interval and clinical context matter.

What are normal PaCO₂ and bicarbonate values?
Typical adult arterial ranges are PaCO₂ 35–45 mmHg and bicarbonate 22–26 mmol/L. Ranges can differ among laboratories and settings.

Can pH be normal when PaCO₂ or bicarbonate is abnormal?
Yes. Compensation or two opposing acid–base processes can leave pH inside its reference interval even when PaCO₂ or bicarbonate is outside range.

Are arterial and venous blood gas values the same?
No. Arterial and venous pH and carbon dioxide values differ, and venous oxygen pressure cannot be used as a substitute for arterial oxygen pressure.

What does a PaO₂ of 80–100 mmHg mean?
It is a commonly cited approximate range for an adult at sea level breathing room air. Age, altitude, oxygen treatment and health conditions can change the expected value.

Related

Formula used
in ph | Arterial pH | - | 7.40 | 0 | 14
in paco | PaCO₂ | mmHg | 40 | 0 | 200
in hco | HCO₃⁻ | mmol/L | 24 | 0 | 100
out phn | pH normal-range status (1=yes, 0=no) | - | (ph - 7.35) / abs(ph - 7.35) * 0 + (7.45 - ph) / abs(7.45 - ph) * 0 + 1 | 0
out pacon | PaCO₂ normal-range status (1=yes, 0=no) | - | (paco - 35) / abs(paco - 35) * 0 + (45 - paco) / abs(45 - paco) * 0 + 1 | 0
out hcon | HCO₃⁻ normal-range status (1=yes, 0=no) | - | (hco - 22) / abs(hco - 22) * 0 + (26 - hco) / abs(26 - hco) * 0 + 1 | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →