molecalculator

Moles & Molar Mass

Electron Configuration Mnemonics: Easy Ways to Remember

Calculator No. 01-10283 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Electron configuration mnemonics are memory aids that help you recall the order in which atomic orbitals are filled according to the Aufbau principle. You use them by memorizing a phrase or a visual pattern that encodes the sequence 1s, 2s, 2p, 3s, 3p, 4s, 3d, and so on. The most common mnemonic is the diagonal rule (or Madelung rule) diagram, but several word-based phrases also exist for quick recall.

Formula

The electron configuration of an atom is built by filling orbitals in order of increasing energy, following the Aufbau principle. The energy order is given by the sum (n + l), where n is the principal quantum number and l is the azimuthal quantum number (s=0, p=1, d=2, f=3). When two orbitals have the same (n + l), the one with lower n fills first. This yields the familiar sequence:

1s < 2s < 2p < 3s < 3p < 4s < 3d < 4p < 5s < 4d < 5p < 6s < 4f < 5d < 6p < 7s < 5f < 6d < 7p

Each orbital type holds a maximum number of electrons: s=2, p=6, d=10, f=14. To write a configuration, you count electrons from the atomic number (Z) and subtract any ionic charge (positive charge means fewer electrons, negative charge means more).

Worked Example

Take iron (Fe) with Z=26 and no charge. Using the diagonal rule, fill orbitals in order until 26 electrons are placed:

  1. 1s2 (2 electrons, total 2)
  2. 2s2 (total 4)
  3. 2p6 (total 10)
  4. 3s2 (total 12)
  5. 3p6 (total 18)
  6. 4s2 (total 20)
  7. 3d6 (total 26)

The full configuration is 1s2 2s2 2p6 3s2 3p6 4s2 3d6. The calculator above gives the same result for Z=26 and charge=0.

Assumptions

  • The Aufbau principle applies to ground-state (lowest energy) configurations.
  • Hund’s rule and the Pauli exclusion principle are followed: each orbital gets one electron before pairing, and no two electrons share the same set of four quantum numbers.
  • Ionic charge is treated as a simple addition or removal of electrons from the neutral atom (for main-group and most transition metals).
  • For transition metals, the 4s orbital fills before 3d in the neutral atom, but when ionized, electrons are removed from 4s first (e.g., Fe2+ is [Ar] 3d6, not [Ar] 4s2 3d4).

The Diagonal Rule (Madelung Diagram)

The most reliable mnemonic is a visual one: write the orbital types in rows by principal quantum number, then draw diagonal arrows from top right to bottom left. For example:

  • Row 1: 1s
  • Row 2: 2s, 2p
  • Row 3: 3s, 3p, 3d
  • Row 4: 4s, 4p, 4d, 4f
  • Row 5: 5s, 5p, 5d, 5f
  • Row 6: 6s, 6p, 6d
  • Row 7: 7s, 7p

Draw arrows starting from 1s, then down-left to 2s, then down-left to 2p, then 3s, 3p, 4s, 3d, etc. This gives the exact filling order. You can sketch this in seconds on an exam, making it the most practical mnemonic.

Word-Based Mnemonics

Some people prefer phrases where the first letters correspond to orbitals. A common one for the first few orbitals is:

“Silly Penguins Don’t Often Fly; Some Penguins Do Fly; Some Don’t Fly; Some Do Fly; Some Don’t; Some Do.”

Here, S = s, P = p, D = d, F = f. The phrase encodes the order: s, p, s, p, s, p, d, p, s, d, p, s, f, d, p, s, f, d, p. It’s a bit long, but it covers the entire sequence up to 7p. Another shorter version for the first 10 orbitals: “Sober Physicists Don’t Find Giraffes In Closets” – but that one only gives the first few (s, p, d, f, g…), so it’s less useful for actual configurations.

For the specific order of sublevels, you can memorize the phrase: “1s, 2s, 2p, 3s, 3p, 4s, 3d, 4p, 5s, 4d, 5p, 6s, 4f, 5d, 6p, 7s, 5f, 6d, 7p” as a rhythm, similar to memorizing a song. Many students find the diagonal rule easier because it doesn’t require remembering a phrase.

How to Choose a Mnemonic

Choose based on your learning style:

  • Visual learners: Use the diagonal rule diagram. It’s fast and you can recreate it from memory.
  • Auditory learners: Use a phrase or chant. Repeat the orbital sequence aloud until it sticks.
  • Kinesthetic learners: Write the diagonal rule by hand several times. The physical act of drawing arrows helps memory.
  • For quick recall: Memorize the first 10 orbitals (up to 3p) which cover the first 18 elements, then use the diagonal rule for the rest.

No single mnemonic is “best” – the key is to practice writing configurations for elements in different periods. For example, write the configuration for potassium (Z=19) and calcium (Z=20) to reinforce that 4s fills before 3d.

Common Mistakes and Misconceptions

One frequent error is assuming that 3d fills before 4s because 3d has a lower principal quantum number. In reality, 4s has lower energy (n+l = 4+0 = 4) than 3d (3+2 = 5), so 4s fills first. Another mistake is forgetting that after filling 4s, the 3d orbitals fill next, not 4p. Also, when writing configurations for ions, many students incorrectly keep the 4s electrons. For transition metals, remove 4s electrons first because they are the outermost (higher n) and less tightly bound.

A common misconception is that the diagonal rule is a law of nature. It’s actually a mnemonic for the Madelung rule, which works for most elements but has exceptions (e.g., chromium and copper). For chromium (Z=24), the actual configuration is [Ar] 3d5 4s1, not [Ar] 3d4 4s2, because a half-filled d subshell is more stable. Similarly, copper (Z=29) is [Ar] 3d10 4s1. These exceptions arise from electron-electron repulsion and exchange energy, and they are not predicted by simple mnemonics.

Alternatives to Mnemonics

If mnemonics don’t work for you, consider using the periodic table itself. The block structure of the periodic table (s-block, p-block, d-block, f-block) directly shows the filling order: read periods left to right, and blocks from top to bottom. For example, the fourth period starts with 4s (K, Ca), then 3d (Sc–Zn), then 4p (Ga–Kr). This is a natural visual mnemonic that many chemists prefer.

Another alternative is to memorize the noble gas shorthand: write the noble gas core in brackets, then only the outer electrons. For example, chlorine is [Ne] 3s2 3p5. This reduces the amount you need to memorize, especially for heavy elements.

Frequently Asked Questions

Q: What is the easiest mnemonic for electron configuration?
The diagonal rule diagram is the easiest for most people because it’s visual and can be drawn in seconds. Write the orbitals in rows by n, then draw diagonal arrows from top right to bottom left.

Q: Why does 4s fill before 3d?
Because the energy of an orbital is roughly proportional to (n + l). For 4s, n+l = 4+0 = 4; for 3d, n+l = 3+2 = 5. Lower (n+l) means lower energy, so 4s fills first.

Q: Does the Aufbau principle always work?
No. There are exceptions like chromium and copper where a half-filled or fully filled d subshell is more stable. The Aufbau principle is a good rule of thumb for most elements, but you should memorize the exceptions.

Q: How do I write the configuration for an ion?
First write the neutral atom’s configuration. Then remove electrons from the highest n orbital (for transition metals, remove 4s before 3d). For a positive ion, subtract electrons; for a negative ion, add electrons to the next available orbital.

Q: Is there a mnemonic for the order of orbitals up to 7p?
Yes, the phrase “Silly Penguins Don’t Often Fly; Some Penguins Do Fly; Some Don’t Fly; Some Do Fly; Some Don’t; Some Do” encodes the full sequence. Alternatively, just memorize the diagonal rule, which gives you the order without a phrase.

Q: Can I use the periodic table instead of a mnemonic?
Absolutely. The periodic table is organized by blocks that match the filling order. Reading the table from left to right and top to bottom gives you the configuration directly, especially if you use noble gas shorthand.

Limits of Mnemonics

Mnemonics are tools for recall, not explanations. They don’t account for exceptions or relativistic effects in heavy elements. For elements beyond lawrencium (Z=103), the filling order becomes less predictable due to relativistic effects and electron correlation. Always verify with a reliable periodic table or computational chemistry data when in doubt. In practice, for most chemistry courses up to undergraduate level, the diagonal rule works fine for the first 100 or so elements, with the notable exceptions of Cr, Cu, Nb, Mo, Ru, Rh, Pd, Ag, Pt, and Au.

Follow your instructor’s guidance and your periodic table when writing configurations. Remember that the mnemonic is a shortcut, not a substitute for understanding the underlying quantum mechanics.

Related

Formula used
in z | Atomic number (Z) | - | 26 | 1
in charge | Ionic charge | - | 0 | -8
out config | Electron configuration | - | "" | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →