molecalculator

Moles & Molar Mass

Ethanol and Methanol Formula? Structure & Uses

Calculator No. 01-8946 · Updated · Formula and assumptions shown below

Molarity 1.0000 mol/L
Concentration in millimolar
1,000.00 mM
= Molarity × 1000
Mass of alcohol
46.07 g
Set in the form below
Molar mass
46.07 g/mol
Set in the form below
You enter
Mass of alcohol (g), Molar mass (g/mol), Final solution volume (mL)
You get
Molarity (mol/L), Concentration in millimolar (mM)
Rounding
4 dp · 2 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Ethanol has the chemical formula C2H5OH (or C2H6O), and methanol has the formula CH3OH (or CH4O). Both are simple alcohols, but they differ by one carbon atom, which gives them very different properties and uses.

Formula

The general formula for a monohydric alcohol is CnH2n+1OH. For ethanol, n = 2, giving C2H5OH; for methanol, n = 1, giving CH3OH. The molar mass is calculated from atomic weights: carbon (C) = 12.011, hydrogen (H) = 1.008, oxygen (O) = 15.999. For ethanol: (2 × 12.011) + (6 × 1.008) + 15.999 = 46.07 g/mol. For methanol: 12.011 + (4 × 1.008) + 15.999 = 32.04 g/mol.

Worked Example

Using the calculator defaults: you have 46.07 g of ethanol (1 mole) and want to make 1000 mL of solution. First, convert volume to liters: 1000 mL ÷ 1000 = 1 L. Then apply the molarity formula: M = mass / (molar mass × volume in L) = 46.07 g / (46.07 g/mol × 1 L) = 1.0000 mol/L. The calculator shows 1.0000 M, and in millimolar: 1.0000 × 1000 = 1000.00 mM.

Assumptions

  • The solute is pure and completely dissolved; no volume change upon mixing.
  • Temperature is 25 °C (density of water ≈ 1 g/mL).
  • The final volume is measured after dissolving, not the solvent volume added.

Structural Differences and Why They Matter

Both molecules have a hydroxyl group (–OH) attached to a carbon chain. Methanol has one carbon; ethanol has two. This single extra carbon changes the boiling point (methanol 64.7 °C, ethanol 78.4 °C), density (0.792 vs 0.789 g/mL), and toxicity dramatically. Methanol is metabolized in the body to formaldehyde and formic acid, which can cause blindness and death; ethanol is metabolized to acetaldehyde and then acetic acid, which is far less toxic. This is why methanol is never used in beverages, while ethanol is the intoxicating ingredient in alcoholic drinks.

Common Uses and Applications

  • Ethanol: alcoholic beverages, solvent in pharmaceuticals and perfumes, fuel additive (E10, E85), antiseptic wipes.
  • Methanol: industrial solvent, antifreeze, windshield washer fluid, biodiesel production (transesterification), laboratory reagent.
  • Both are used as denaturants – methanol is often added to ethanol to make it unfit for drinking (denatured alcohol).

How to Choose Between Them

Choose based on the application. For human consumption or medical use, only ethanol (food grade) is safe. For industrial processes requiring a cheap, polar solvent, methanol is often preferred because it is cheaper and has a lower boiling point (easier to evaporate). In the lab, both are common; check your protocol – if it says “methanol,” never substitute ethanol because the reaction kinetics or solubility may change. Also note that methanol is highly toxic by skin absorption and inhalation, so always work in a fume hood with gloves.

Common Mistakes and Misconceptions

A frequent error is confusing the two formulas: students often write CH3OH for ethanol or C2H5OH for methanol. Another misconception is that methanol is “just like ethanol but cheaper” – it is not safe to drink. Also, when calculating molarity, people forget to convert mL to L, or use the wrong molar mass (e.g., using 32 g/mol for ethanol). Always double-check the molecular formula before any calculation.

Safety and Handling

Methanol is a poison: even small amounts can cause blindness or death. It is also flammable. Ethanol is also flammable and can be intoxicating, but it is far less acutely toxic. When handling either, follow your lab method, the safety data sheet (SDS) and your supervisor. Never taste or smell chemicals directly. If methanol exposure is suspected, seek medical attention immediately – the antidote is ethanol or fomepizole, which competes for the same enzyme.

Frequently Asked Questions

Is methanol the same as wood alcohol?

Yes, methanol is historically called wood alcohol because it was produced by destructive distillation of wood. The name “wood alcohol” is still used informally, but the chemical is the same: CH3OH.

Can I use ethanol instead of methanol in my car?

Not without modification. Ethanol is used in flex-fuel vehicles (E85), but methanol has different corrosivity and energy content. Most standard gasoline engines can handle low ethanol blends (E10), but methanol requires special seals and tuning. Always consult your vehicle manual.

Why does methanol cause blindness?

When metabolized in the liver, methanol is converted to formaldehyde and then formic acid. Formic acid is toxic to the optic nerve and retina, leading to permanent damage. Ethanol competes for the same enzyme (alcohol dehydrogenase), which is why drinking ethanol can slow methanol metabolism and prevent toxicity.

What is the difference between ethanol and ethyl alcohol?

They are the same compound. “Ethanol” is the systematic IUPAC name, while “ethyl alcohol” is a common name. The formula is the same: C2H5OH.

How do I calculate the molarity of a 70% ethanol solution?

First, assume you have 100 mL of solution: 70 mL ethanol (density 0.789 g/mL) gives 55.23 g ethanol. Moles = 55.23 g / 46.07 g/mol = 1.199 mol. Then divide by 0.1 L (100 mL) to get 11.99 M. For precise work, use the actual density and final volume.

Related

Formula used
in m | Mass of alcohol | g | 46.07 | 0
in mm | Molar mass | g/mol | 46.07 | 0.001
in v | Final solution volume | mL | 1000 | 0.001
out c | Molarity | mol/L | m / mm / (v / 1000) | 4
out cmm | Concentration in millimolar | mM | c * 1000 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →