molecalculator

Moles & Molar Mass

Glucose Monohydrate Molar Mass: 198.17 g/mol

Calculator No. 01-9874 · Updated · Formula and assumptions shown below

Molarity 0.0590 mol/L
Concentration in millimolar
58.98 mM
= Molarity × 1000
Mass of solute
2.922 g
Set in the form below
Molar mass
198.17 g/mol
Set in the form below
You enter
Mass of solute (g), Molar mass (g/mol), Final solution volume (mL)
You get
Molarity (mol/L), Concentration in millimolar (mM)
Rounding
4 dp · 2 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Glucose monohydrate (C6H12O6·H2O) has a molar mass of 198.17 g/mol. This value is the sum of the atomic weights of 6 carbon, 12 hydrogen, 7 oxygen (the extra oxygen comes from the water of crystallization), and 1 water molecule. You use this molar mass whenever you weigh glucose monohydrate for solution preparation, because the water is part of the solid crystals.

Formula

The molar mass of glucose monohydrate is calculated by adding the atomic masses of all atoms in the formula unit C6H12O6·H2O:

M(C6H12O6·H2O) = 6×M(C) + 14×M(H) + 7×M(O)

Using IUPAC standard atomic weights: C = 12.011 g/mol, H = 1.008 g/mol, O = 15.999 g/mol.

M = 6(12.011) + 14(1.008) + 7(15.999) = 72.066 + 14.112 + 111.993 = 198.171 g/mol, usually rounded to 198.17 g/mol.

Note that the hydrogen count is 14, not 12, because the water molecule adds two hydrogen atoms. The oxygen count is 7 (six in glucose plus one in water).

Worked Example

You need to prepare 250 mL of a 0.060 mol/L glucose monohydrate solution. How many grams do you weigh?

Step 1: Convert volume to liters: 250 mL = 0.250 L.

Step 2: Use the molarity formula: moles = molarity × volume (L) = 0.060 mol/L × 0.250 L = 0.0150 mol.

Step 3: Convert moles to mass using the molar mass: mass = moles × molar mass = 0.0150 mol × 198.17 g/mol = 2.97255 g ≈ 2.973 g.

The calculator above with default inputs (2.922 g, 198.17 g/mol, 250 mL) gives a molarity of 0.05898 mol/L ≈ 0.0590 mol/L. That corresponds to 0.0147 mol of glucose monohydrate in 250 mL. The difference from the example (0.0150 mol) is because the default mass is slightly lower; adjust the mass input to 2.973 g to get exactly 0.0600 mol/L.

Assumptions

  • The glucose monohydrate is pure and fully dissolved.
  • The final volume is exactly 250 mL after dissolving, not 250 mL of water added to the solid (volume changes on dissolution).
  • The molar mass is based on the monohydrate form, not anhydrous glucose.
  • Temperature is not a factor because molarity is based on volume at the preparation temperature; slight volume changes with temperature are ignored.

Anhydrous vs. Monohydrate: Why the Difference Matters

Anhydrous glucose (C6H12O6) has a molar mass of 180.16 g/mol. The monohydrate form includes one water molecule per glucose unit, adding 18.015 g/mol. The difference is about 18 g/mol, which is 10% of the anhydrous mass. If you use the wrong molar mass, your solution concentration will be off by roughly 10%—a significant error in most lab work. For example, to make 1 L of 1 M glucose solution, you need 180.16 g of anhydrous glucose but 198.17 g of monohydrate. Many suppliers sell glucose monohydrate by default, so always check the label.

How to Use the Molar Mass in Solution Preparation

When preparing a solution from glucose monohydrate, follow these steps:

  1. Determine the desired molarity (M) and final volume (V in L).
  2. Calculate required moles: n = M × V.
  3. Calculate required mass: mass = n × 198.17 g/mol (for monohydrate).
  4. Weigh the solid accurately on an analytical balance.
  5. Dissolve in a beaker with about 80% of the final volume of distilled water.
  6. Transfer to a volumetric flask, rinse the beaker, and bring to the mark with water.
  7. Mix thoroughly. The final volume, not the water added, defines the molarity.

For example, to make 500 mL of 0.5 M glucose monohydrate: n = 0.5 × 0.5 = 0.25 mol; mass = 0.25 × 198.17 = 49.5425 g ≈ 49.54 g.

Common Mistakes and How to Avoid Them

  • Using the anhydrous molar mass: Always confirm whether your reagent is monohydrate or anhydrous. The label usually states “monohydrate” or “D-(+)-glucose monohydrate.”
  • Forgetting the water of hydration: The water is part of the crystal, so it contributes to the mass you weigh. It does not contribute to the number of glucose molecules in solution, but it does affect the mass needed.
  • Adding solvent to reach volume vs. dissolving then adjusting: Always dissolve the solid in less than the final volume, then add water to the mark. If you add 250 mL water to 2.922 g of solid, the final volume may be slightly more than 250 mL, making the concentration lower than intended.
  • Rounding too early: Use at least 4 significant figures in intermediate calculations. Round only the final answer.
  • Confusing molarity with molality: Molarity (mol/L) uses solution volume; molality (mol/kg) uses solvent mass. This page is for molarity.

Why the Molar Mass Is Not a Whole Number

Atomic weights are averages of naturally occurring isotopes. Carbon-12 is exactly 12, but carbon also has small amounts of carbon-13, raising the average to 12.011. Similarly, oxygen has isotopes O-16, O-17, and O-18, giving an average of 15.999. Hydrogen averages 1.008 because of deuterium. These averages are why the molar mass of glucose monohydrate is 198.17 g/mol, not an integer. In high-precision work, you may need to use the exact atomic weights from the IUPAC table, but 198.17 is sufficient for most laboratory calculations.

Frequently Asked Questions

Is glucose monohydrate the same as D-glucose?

D-glucose is the common stereoisomer of glucose. Glucose monohydrate is D-glucose with one water molecule of crystallization. Anhydrous D-glucose has no water. Both forms are used in labs; the monohydrate is often used because it is less hygroscopic (absorbs less moisture from air) and easier to weigh accurately.

How do I convert mass of glucose monohydrate to moles of anhydrous glucose?

Divide the mass by 198.17 g/mol to get moles of glucose monohydrate, which equals moles of anhydrous glucose because each monohydrate unit contains one glucose molecule. For example, 19.817 g of monohydrate is 0.1000 mol of glucose.

What is the molar mass of glucose monohydrate in kg/mol?

It is 0.19817 kg/mol. To convert g/mol to kg/mol, divide by 1000. This is useful when using the ideal gas law or other equations that require SI units.

Does the water in glucose monohydrate affect the concentration of glucose in solution?

No. When dissolved, the water molecule becomes part of the solvent. The number of glucose molecules in solution depends only on the moles of monohydrate, which is mass divided by 198.17. The water does not change the molarity of glucose itself.

Can I use glucose monohydrate to make a 1 M solution without adjusting for the water?

You must use the monohydrate molar mass. To make 1 L of 1 M glucose, weigh 198.17 g of monohydrate (not 180.16 g). If you weigh only 180.16 g of monohydrate, you will get a 0.909 M solution, not 1 M.

Why does the calculator show 0.05898 M for the default 2.922 g?

2.922 g divided by 198.17 g/mol gives 0.01475 mol. Dividing by 0.250 L gives 0.05898 M. The default mass was chosen to give a round number in millimoles (14.75 mmol) but not a round molarity. You can change the mass to 2.9725 g to get exactly 0.0600 M.

Related

Formula used
in m | Mass of solute | g | 2.922 | 0
in mm | Molar mass | g/mol | 198.17 | 0.001
in v | Final solution volume | mL | 250 | 0.001
out c | Molarity | mol/L | m / mm / (v / 1000) | 4
out cmm | Concentration in millimolar | mM | c * 1000 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →