molecalculator

Moles & Molar Mass

Half-Life Alpha: Meaning, Formula & Calculator

Calculator No. 01-6982 · Updated · Formula and assumptions shown below

Remaining amount 8.562988 g
Fraction remaining
0.856299
= 0.5^(Elapsed time ÷ Half-life)
Initial amount
10 g
Set in the form below
Half-life
4468000000 years
Set in the form below
You enter
Initial amount (g), Half-life (years), Elapsed time (years)
You get
Remaining amount (g), Fraction remaining
Rounding
6 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Half-life (symbol t½) is the time required for half of the radioactive atoms in a sample to decay. For alpha decay, this is the time it takes for half of a parent nuclide to emit an alpha particle (a helium-4 nucleus) and transform into a daughter nuclide. This page provides a calculator that computes the remaining quantity of a radioactive substance after a given time, based on its half-life and initial amount, and explains the underlying physics and mathematics.

Formula

The decay of a radioactive isotope follows first-order kinetics. The remaining amount N(t) after time t is given by:

N(t) = N0 × (1/2)t / t½

where:

  • N0 = initial amount (in grams, moles, or number of atoms)
  • t½ = half-life (in the same time unit as t)
  • t = elapsed time (years, seconds, etc.)

This formula works for any decay process, not just alpha decay, as long as the decay is exponential. The calculator uses grams for the amount and years for time, but you can enter any consistent units.

Worked Example

Using the defaults from the calculator: initial amount = 10 g, half-life = 4.468×109 years (the half-life of uranium-238), and elapsed time = 1×109 years.

Step 1: Compute the exponent: t / t½ = 1×109 / 4.468×109 = 0.22381.

Step 2: Compute (1/2)0.22381 = e0.22381 × ln(0.5) = e0.22381 × (-0.693147) = e-0.15513 = 0.85632.

Step 3: Multiply by initial amount: 10 g × 0.85632 = 8.5632 g.

So after 1 billion years, about 8.563 g of uranium-238 remains from a 10 g sample. The calculator rounds to 6 decimal places, giving 8.563200 g.

Assumptions

  • The decay follows a simple exponential law (no branching, no decay chains affecting the parent).
  • The half-life is constant over time and under all conditions (temperature, pressure, chemical state do not affect alpha decay).
  • The sample is pure and no daughter products are being counted as parent.
  • Time units are consistent; if you input years for half-life and seconds for elapsed time, the result will be wrong.

What Is Alpha Decay?

Alpha decay is a type of radioactive decay in which an unstable nucleus ejects an alpha particle—two protons and two neutrons bound together, identical to a helium-4 nucleus. This reduces the atomic number by 2 and the mass number by 4. For example, uranium-238 decays to thorium-234:

238U → 234Th + 4He

Alpha decay is common among heavy elements (atomic number > 82) because alpha emission reduces the nucleus’s energy. The emitted alpha particle carries kinetic energy (typically 4–9 MeV) and is relatively heavy and slow, so it can be stopped by a sheet of paper or a few centimeters of air.

How to Use the Calculator

Enter the initial amount of the radioactive substance (in grams), its half-life (in years), and the elapsed time (in years). The calculator returns the remaining amount and the fraction of the original that remains. To use different units (e.g., milligrams or seconds), simply convert them to grams and years before entering, or keep the same units for both half-life and time (the formula is unit-agnostic).

For example, to find how much of a 2 mg sample of polonium-210 (half-life 138.376 days) remains after 30 days, convert days to years: 138.376 days = 0.3788 years, 30 days = 0.08214 years. Enter initial amount as 0.002 g (or use grams), half-life as 0.3788, time as 0.08214. The result will be in the same unit you entered (g).

Common Mistakes and Misconceptions

  • Mixing units: Using half-life in years and time in days without conversion. Always use the same time unit for both.
  • Confusing half-life with decay constant: The decay constant λ (lambda) is related by t½ = ln(2)/λ. The formula above uses half-life directly, so you don’t need λ.
  • Thinking half-life means the substance is gone after two half-lives: After two half-lives, 25% remains; after three, 12.5%, and so on. It never reaches zero mathematically.
  • Assuming alpha decay is the only decay mode: Many isotopes have multiple decay pathways (e.g., beta decay), but the half-life is the overall half-life for all modes combined.

Why Half-Life Matters in Practice

Half-life is used in radiometric dating (e.g., carbon-14 for archaeology, uranium-lead for geology), nuclear medicine (to plan doses and storage), nuclear waste management (to determine how long waste must be isolated), and in environmental science (to model contamination spread). For alpha emitters, the half-life also determines the specific activity—the number of decays per second per gram—which is inversely proportional to half-life. A short half-life means high activity and high hazard per gram.

Limitations of the Formula

The simple exponential formula assumes a closed system with no gain or loss of the parent isotope other than decay. In reality, if a sample is part of a decay chain (e.g., uranium-238 decays through many daughters), the amount of a daughter isotope depends on its own half-life and the decay of its parent. The calculator here is for a single isotope, not for a chain. Also, for extremely short half-lives (fractions of a second), measurements may be difficult, but the math remains valid.

Frequently Asked Questions

What is the half-life of alpha particles?

Alpha particles themselves do not have a half-life; they are particles, not radioactive isotopes. The half-life belongs to the decaying nucleus that emits the alpha particle. For example, the half-life of radon-222 is 3.823 days, and it emits alpha particles.

Can alpha decay be accelerated or slowed?

No. For a given isotope, the half-life is constant under normal conditions. Extreme conditions like ionization (stripping all electrons) can slightly change the half-life for some isotopes (e.g., in stars), but for practical purposes on Earth, it is fixed.

How do I calculate the half-life if I know the amount remaining?

Rearrange the formula: t½ = t × ln(2) / ln(N0/N). For example, if you start with 10 g and have 2.5 g after 10 years, then t½ = 10 × ln(2) / ln(10/2.5) = 10 × 0.6931 / 1.3863 = 5.0 years.

What is the difference between alpha decay and beta decay?

Alpha decay emits a helium nucleus (2 protons, 2 neutrons), reducing atomic number by 2. Beta decay emits an electron or positron, changing a neutron to a proton (or vice versa) without changing mass number. Alpha decay is common in heavy nuclei; beta decay occurs in neutron-rich or proton-rich nuclei.

Is alpha radiation dangerous?

Alpha particles are ionizing but have low penetration—they cannot pass through the outer dead layer of skin. However, if an alpha-emitting substance is inhaled or ingested, it can damage internal tissues and DNA, increasing cancer risk. Therefore, alpha emitters are particularly hazardous when internalized.

Safety Note

This calculator is for educational and study purposes. If you are working with radioactive materials in a laboratory, always follow your institution’s safety protocols, the safety data sheet (SDS), and your supervisor’s instructions. Use appropriate shielding and monitoring, and never handle radioactive sources without proper training.

Related

Formula used
in a0 | Initial amount | g | 10 | 0
in t12 | Half-life | years | 4.468e9 | 1e-12
in t | Elapsed time | years | 1e9 | 0
out a | Remaining amount | g | a0 * 0.5^(t / t12) | 6
out frac | Fraction remaining | - | 0.5^(t / t12) | 6

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →