Half-life kinetic energy refers to the kinetic energy of particles emitted during radioactive decay, and it is directly related to the decay energy (Q-value) of the nuclear reaction. You enter the mass of the parent and daughter nuclei (or the Q-value directly) and the calculator returns the kinetic energy carried by the emitted particle, typically an alpha or beta particle. This page explains the physics, shows the formula, and provides a working calculator for the most common case: alpha decay.
Formula
The decay energy (Q-value) is the difference between the mass of the parent nucleus and the total mass of the products, converted to energy using Einstein’s mass–energy equivalence:
Q = (m_parent – m_daughter – m_particle) × 931.49410242 MeV/u
where:
- m_parent – mass of the parent nucleus in atomic mass units (u)
- m_daughter – mass of the daughter nucleus in u
- m_particle – mass of the emitted particle (alpha, beta, etc.) in u
- 931.49410242 – conversion factor: 1 u = 931.49410242 MeV/c²
In alpha decay, the Q-value is shared between the alpha particle and the recoiling daughter nucleus. Because momentum is conserved, the lighter alpha particle carries most of the kinetic energy:
KEalpha = Q × (1 – malpha / mparent)
KEdaughter = Q × (malpha / mparent)
These equations assume the parent nucleus is initially at rest.
Worked Example
Consider the alpha decay of uranium-238 into thorium-234 plus an alpha particle (helium-4 nucleus). Using the default values in the calculator:
m_parent = 238.050788 u, m_daughter = 234.043601 u, m_alpha = 4.002603 u
- Calculate the mass defect: Δm = 238.050788 – 234.043601 – 4.002603 = 0.004584 u
- Convert to energy: Q = 0.004584 × 931.49410242 = 4.2699 MeV
- Alpha particle kinetic energy: KEalpha = 4.2699 × (1 – 4.002603/238.050788) = 4.2699 × 0.98319 = 4.198 MeV
- Daughter recoil energy: KEdaughter = 4.2699 × (4.002603/238.050788) = 4.2699 × 0.01681 = 0.0718 MeV
The calculator rounds to 4 decimal places, giving Q = 4.2699 MeV, KE_alpha = 4.1980 MeV, KE_daughter = 0.0718 MeV. The alpha particle gets about 98.3% of the energy.
Assumptions
- The parent nucleus is at rest before decay.
- Masses used are nuclear masses, not atomic masses. (For alpha decay, using atomic masses gives the same Q because the electron count cancels, but for beta decay you must use nuclear masses or correct for electron masses.)
- No gamma-ray emission is considered; if a gamma photon is emitted, the particle kinetic energy is reduced by the photon energy.
- The decay is two-body (parent → daughter + particle). For beta decay, the neutrino carries away a variable share, so the beta particle does not have a single kinetic energy.
Why Half-Life Matters
Half-life (t1/2) is the time required for half of the radioactive nuclei in a sample to decay. It is a statistical measure that tells you how quickly a sample loses activity, but it does not tell you the energy of the emitted particles. Two isotopes can have identical half-lives but very different decay energies. For example, tritium (hydrogen-3) has a half-life of 12.3 years and emits a beta particle with a maximum energy of only 18.6 keV, while cobalt-60 has a half-life of 5.27 years and emits gamma rays with energies over 1 MeV. The kinetic energy of the emitted particle is set by the nuclear mass difference, not by the half-life.
How to Use the Calculator
To use this calculator, you need the nuclear masses of the parent, daughter, and emitted particle. These are available from standard nuclear data tables (e.g., the Atomic Mass Evaluation). For alpha decay, you can also use atomic masses because the electron masses cancel. For beta decay, you must use nuclear masses or adjust for the electron mass difference.
Steps:
- Enter the mass of the parent nucleus in atomic mass units (u).
- Enter the mass of the daughter nucleus.
- Enter the mass of the emitted particle (alpha = 4.002603 u, beta = 0.00054858 u for electron, etc.).
- Read the Q-value and the kinetic energy of the particle and daughter.
The first output (Q) is the total energy released. The second and third outputs show how that energy is split between the particle and the recoiling daughter.
Common Mistakes and Misconceptions
- Confusing atomic and nuclear masses: For beta decay, using atomic masses without subtracting the electron mass gives a wrong Q-value. Always use nuclear masses for beta decay.
- Assuming all particles get the same energy: In beta decay, the energy is shared with a neutrino, so the beta particle has a continuous spectrum from zero up to the Q-value. The calculator here is for alpha decay, where the alpha particle has a discrete energy.
- Ignoring recoil: The daughter nucleus recoils with a small but non-zero kinetic energy. This is often neglected in simple discussions, but it is necessary for precise calculations.
- Using half-life to estimate energy: Half-life and decay energy are independent properties. A short half-life does not mean high energy, and vice versa.
Limits of the Formula
The formula assumes a two-body final state. In alpha decay, this is usually a good approximation unless the daughter nucleus is left in an excited state, which then emits a gamma ray. In that case, the alpha particle energy is slightly lower than the Q-value. For beta decay, the presence of the neutrino means the beta particle does not have a fixed kinetic energy; the formula gives the maximum possible energy (the endpoint energy). This calculator is therefore most accurate for alpha decay and for the total Q-value of any decay.
Frequently Asked Questions
Does half-life affect kinetic energy?
No. Half-life is a measure of decay probability over time, while kinetic energy is determined by the mass difference between the parent and products. Two nuclides with the same half-life can have very different particle energies. For example, both polonium-214 and radon-220 have half-lives around 55 seconds, but their alpha particle energies differ by about 1 MeV.
Why does the alpha particle get most of the kinetic energy?
Because momentum is conserved. In a two-body decay, the lighter particle must move faster to balance the momentum of the heavier recoiling daughter. Kinetic energy is proportional to the square of velocity, so the lighter particle carries a larger share. The exact split is given by KE_alpha = Q × (1 – m_alpha/m_parent).
What is the Q-value in nuclear decay?
The Q-value is the total energy released in a nuclear reaction or decay. It equals the difference in rest mass energy between the initial and final states. For decay to occur spontaneously, Q must be positive. The Q-value is shared among the products as kinetic energy and any emitted gamma rays.
Can I use atomic masses instead of nuclear masses?
For alpha decay, yes, because the number of electrons on both sides is the same, so the electron masses cancel. For beta decay, you must be careful: the beta particle (electron) adds an electron mass to the products, so using atomic masses without correction will give a Q-value that is off by 0.511 MeV (the electron rest mass).
Why is beta decay energy continuous?
In beta decay, a neutrino (or antineutrino) is emitted along with the beta particle. The energy is shared randomly between the two, so the beta particle can have any energy from zero up to the Q-value. This is why beta spectra are continuous, unlike alpha spectra which show discrete lines.
How do I find the nuclear masses?
Nuclear masses are tabulated in the Atomic Mass Evaluation (AME) and in many nuclear physics textbooks. You can also find them online at the IAEA or NNDC databases. For alpha decay, you can use atomic masses from a periodic table and subtract the electron masses if needed, but for most practical purposes, using atomic masses directly works for alpha decay.
When performing actual lab work, always follow your institution’s safety procedures, the material safety data sheets (SDS) for any radioactive materials, and the guidance of your supervisor.
Related
Formula used
in m | Mass of parent nucleus (u) | u | 238.050788 | 1 in md | Mass of daughter nucleus (u) | u | 234.043601 | 1 in ma | Mass of alpha particle (u) | u | 4.002603 | 1 out q | Decay energy Q (MeV) | MeV | (m - md - ma) * 931.49410242 | 4 out ke_alpha | Alpha particle kinetic energy (MeV) | MeV | q * (1 - ma / m) | 4 out ke_daughter | Daughter nucleus recoil energy (MeV) | MeV | q * (ma / m) | 4
Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work
Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.
More in this section
- Normality to g/L Converter & Formula29.220 g/L
- Normality to meq/mL Conversion Calculator1.0000 meq/mL
- Normality Test Results: How to Analyze Them
- Normality Test Q-Q Plot: How to Read It
- Normality Slay the Spire?
- Normality Test for Paired t Test: How to Check