molecalculator

Moles & Molar Mass

Kp Calculator for Sepsis: What It Means and Limits

Calculator No. 01-4038 · Updated · Formula and assumptions shown below

Kp respiratory index, PaO₂/FiO₂ 200 mmHg
Arterial oxygen pressure, PaO₂
80 mmHg
Set in the form below
Inspired oxygen fraction, FiO₂
0.4 fraction (0–1)
Set in the form below
You enter
Arterial oxygen pressure, PaO₂ (mmHg), Inspired oxygen fraction, FiO₂ (fraction (0–1))
You get
Kp respiratory index, PaO₂/FiO₂ (mmHg)
Rounding
0 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

“Kp calculator sepsis” usually refers to an online tool for calculating the respiratory index Kp from blood-gas measurements—not a validated calculator for diagnosing sepsis. Kp is commonly calculated as PaO₂/FiO₂, the arterial oxygen partial pressure divided by the fraction of inspired oxygen; it describes oxygenation and must be interpreted alongside the patient’s condition and other clinical information.

Formula

Kp = PaO₂ / FiO₂. PaO₂ is the arterial partial pressure of oxygen, entered in mmHg. FiO₂ is the fraction of oxygen in the gas being breathed, entered as a decimal from 0 to 1. For example, 21% oxygen is 0.21, not 21. The result is a ratio conventionally reported in mmHg; FiO₂ is dimensionless. The calculator reports the arithmetic only. It does not determine whether someone has sepsis, acute respiratory distress syndrome (ARDS), or another condition.

Worked Example

Using the calculator’s default inputs:

  • PaO₂ = 80 mmHg
  • FiO₂ = 0.4

Kp = PaO₂ / FiO₂ = 80 / 0.4 = 200 mmHg.

Assumptions

  • PaO₂ and FiO₂ values come from measurements or a clinical record and are entered correctly.
  • FiO₂ is expressed as a fraction, not a percentage.
  • The formula gives a ratio, not a diagnosis or treatment recommendation.

What Kp Measures—and What It Does Not

Kp is an oxygenation index sometimes called the P/F ratio. It compares the oxygen pressure measured in arterial blood with the oxygen concentration supplied in the inhaled gas. At the same PaO₂, a higher FiO₂ produces a lower ratio, indicating that more inspired oxygen was needed to achieve that blood oxygen pressure. A lower ratio can signal impaired oxygenation, but it does not identify the cause.

Sepsis is a potentially life-threatening organ dysfunction caused by a dysregulated response to infection. Its assessment draws on the overall clinical picture, including suspected infection, organ function, vital signs, examination, and laboratory findings. There is no single Kp cutoff that diagnoses sepsis. A person can have sepsis without a low Kp, and a low Kp can occur for reasons other than sepsis, including pneumonia, fluid in the lungs, or other forms of respiratory failure.

“Kp” is not as universally standardized a label as “PaO₂/FiO₂” or “P/F ratio.” If a particular website or form calls a different measurement Kp, check its definition before relying on the result. This calculator uses Kp to mean PaO₂ divided by FiO₂.

How to Enter the Values Correctly

  1. Use PaO₂, not oxygen saturation. PaO₂ is the arterial oxygen pressure from an arterial blood gas, typically reported in mmHg or kPa. Oxygen saturation (SpO₂ or SaO₂) is a percentage and cannot be substituted directly into this formula.
  2. Convert FiO₂ to a fraction. Divide a percentage by 100: 40% becomes 0.40 and 100% becomes 1.00. Entering 40 instead of 0.40 makes the calculated result one hundred times too small.
  3. Use values from a clinically meaningful time. PaO₂ and oxygen support can change quickly. A ratio is most interpretable when the measurements reflect the same period and the support setting is known.
  4. Check pressure units. If PaO₂ is recorded in kPa, convert it before entering it: 1 kPa = 7.50062 mmHg. Alternatively, divide a kPa PaO₂ by the FiO₂ to obtain a ratio in kPa, but do not compare that number directly with thresholds stated in mmHg.

For example, if PaO₂ is 10.0 kPa and FiO₂ is 0.50, converting first gives about 75.0 mmHg; the ratio is about 150 mmHg. Using 10.0 as if it were mmHg would produce a misleading result.

Interpreting the Result and Its Limits

A lower P/F ratio generally means poorer oxygenation relative to the oxygen concentration being breathed. However, interpretation depends on factors beyond the two inputs. In particular, oxygen delivery method and respiratory support matter. The Berlin definition of ARDS uses a PaO₂/FiO₂ threshold of 300 mmHg or less as one criterion, but it also requires other conditions, including timing, imaging findings, and specified positive-pressure support. A ratio alone cannot establish ARDS, and those ARDS criteria are not a sepsis scoring system.

Measurements can also be affected by how and when the blood sample was obtained, changes in oxygen support, ventilation settings, and clinical instability. On some low-flow oxygen devices, the exact FiO₂ a person inhales is not fixed; a documented or estimated value may therefore introduce uncertainty. The calculator cannot correct for these issues, assess symptoms, or decide whether the reported values are reliable.

Do not use a calculator result to delay urgent assessment or to change oxygen or ventilator settings. If a person has severe difficulty breathing, bluish or gray lips, new confusion, collapse, or rapidly worsening illness, seek emergency medical help. Suspected sepsis also requires prompt professional assessment; this page is for explaining the arithmetic, not providing individual medical advice.

Kp Compared with Sepsis Scores

Kp is a ratio about oxygenation. Sepsis screening and severity tools address different questions and use different information. For example, qSOFA uses respiratory rate, systolic blood pressure, and altered mentation to flag some patients with suspected infection who may be at risk of poor outcomes; it is not a diagnostic test and should not replace clinical judgment. Other clinical approaches may incorporate laboratory values and organ dysfunction. None can be reproduced by entering PaO₂ and FiO₂ alone.

This distinction helps resolve a common misconception: a low Kp may point to a serious breathing problem in someone with infection, but it is not a “sepsis score.” Likewise, a normal Kp does not rule out infection or sepsis. Clinicians interpret oxygenation measures in context with the suspected source of infection, organ function, trends, and the full examination.

Frequently Asked Questions

What does Kp mean in sepsis?
Kp often means the PaO₂/FiO₂ ratio, an oxygenation measure. It is not a sepsis diagnostic test or a stand-alone sepsis score.

How do you calculate Kp?
Divide arterial PaO₂ by FiO₂ expressed as a decimal. For PaO₂ of 80 mmHg and FiO₂ of 0.40, Kp is 200 mmHg.

Is a low Kp proof of sepsis?
No. A low ratio indicates impaired oxygenation but does not reveal its cause. Sepsis requires assessment for infection-related organ dysfunction and other clinical evidence.

Can I use oxygen saturation instead of PaO₂?
No. Oxygen saturation is a percentage, while PaO₂ is an arterial pressure measured by a blood-gas test. They are related but are not interchangeable in this formula.

What is a normal Kp value?
There is no single value that diagnoses or excludes sepsis. The ratio is interpreted in context; ARDS criteria use it alongside other clinical requirements, not in isolation.

Related

Formula used
in pa | Arterial oxygen pressure, PaO₂ | mmHg | 80 | 0
in fio | Inspired oxygen fraction, FiO₂ | fraction (0–1) | 0.4 | 0 | 1
out kp | Kp respiratory index, PaO₂/FiO₂ | mmHg | pa / fio | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →