molecalculator

Moles & Molar Mass

Mass of Neutron and Proton in kg, amu & MeV

Calculator No. 01-7797 · Updated · Formula and assumptions shown below

Binding energy per nucleon 0.556 MeV/nucleon
Mass deficit
0.002388 u
Set in the form below
Mass number (A)
4
Set in the form below
You enter
Mass deficit (u), Mass number (A)
You get
Binding energy per nucleon (MeV/nucleon)
Rounding
3 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The neutron has a mass of approximately 1.67492749804 × 10−27 kg (1.00866491595 u), and the proton has a mass of approximately 1.67262192369 × 10−27 kg (1.00727646662 u). In energy units, these correspond to about 939.565 MeV/c² for the neutron and 938.272 MeV/c² for the proton. The difference, though tiny in absolute terms, is about 1.29 MeV/c² and is central to nuclear stability and radioactive decay.

Exact Masses and Units

Physicists quote particle masses in three equivalent ways: kilograms (SI), atomic mass units (u), and mega-electronvolts divided by c² (MeV/c²). The atomic mass unit is defined as exactly 1/12 of the mass of a carbon-12 atom, equal to 1.66053906660 × 10−27 kg. Because mass and energy are interchangeable via E = mc², a mass can be expressed as an energy divided by c². The conversion factor is 1 u = 931.49410242 MeV/c².

  • Neutron: 1.67492749804 × 10−27 kg = 1.00866491595 u = 939.56542052 MeV/c²
  • Proton: 1.67262192369 × 10−27 kg = 1.00727646662 u = 938.27208816 MeV/c²
  • Electron: 9.1093837015 × 10−31 kg = 0.00054857990907 u = 0.51099895000 MeV/c² (for comparison)

These values come from the CODATA 2018 adjustment, the internationally accepted set of fundamental physical constants. The proton mass is known to about 3 parts in 109, while the neutron mass is known slightly less precisely because a free neutron decays with a half-life of about 10 minutes, making direct measurement harder.

Why the Neutron Is Slightly Heavier

The neutron is not an elementary particle; it is composed of three quarks: one up quark and two down quarks. The proton is also three quarks: two up and one down. The up quark has a mass of about 2.2 MeV/c² and the down quark about 4.7 MeV/c², so the simple sum of quark masses gives roughly 9–10 MeV/c² for either particle. The actual masses are around 100 times larger because most of the mass comes from the binding energy of the strong force holding the quarks together, not from the quarks themselves.

The mass difference between the neutron and proton (about 1.29 MeV/c²) is due to the electromagnetic repulsion among the quarks and the slight mass difference between up and down quarks. The down quark is heavier, and the neutron has two down quarks, which explains why the neutron is heavier. This small difference has huge consequences: a free neutron decays into a proton, an electron, and an antineutrino (beta decay) because it is energetically favorable. Inside a stable nucleus, however, the neutron can be bound more tightly than a proton would be, so it does not decay.

Nuclear Binding Energy and Mass Defect

When protons and neutrons combine to form a nucleus, the total mass of the nucleus is less than the sum of the masses of its individual nucleons. This missing mass is called the mass defect, and it is converted into binding energy according to E = mc². The binding energy is the energy required to break the nucleus into separate nucleons.

For example, a helium-4 nucleus (two protons and two neutrons) has a mass of 4.00260325413 u. The sum of two proton masses and two neutron masses is:

2 × 1.00727646662 + 2 × 1.00866491595 = 4.03188276514 u

The mass defect is 4.03188276514 − 4.00260325413 = 0.02927951101 u. Multiplying by 931.49410242 MeV/u gives about 27.27 MeV total binding energy. Dividing by 4 nucleons gives about 6.82 MeV per nucleon. The calculator above lets you compute this for any nucleus given its mass deficit and mass number.

Why the Proton Mass Is Not Just the Sum of Quark Masses

A common misconception is that a proton’s mass is simply the sum of its three valence quarks. In reality, the proton contains not only three valence quarks but also a sea of virtual quark-antiquark pairs and gluons. The energy of these gluons and the kinetic energy of the quarks contribute the bulk of the mass. In fact, the mass of the proton is mostly the energy of the strong force field itself, as described by quantum chromodynamics (QCD).

This is why the proton mass is so hard to calculate from first principles. Lattice QCD calculations, which simulate quarks and gluons on a discrete space-time grid, have reproduced the proton mass to within a few percent, but they require enormous computational resources. The measured values remain the most accurate.

How Are These Masses Measured?

Proton mass is measured using Penning traps, where a single proton is held in a magnetic field and its cyclotron frequency is measured. The frequency depends on the charge-to-mass ratio, and with a known charge, the mass can be derived with extraordinary precision. The most recent measurements achieve a relative uncertainty of 3 × 10−9.

Neutron mass is trickier because the neutron has no charge, so it cannot be trapped electromagnetically. Instead, physicists measure the mass of the deuteron (a proton plus a neutron) and subtract the proton mass. The deuteron mass is well known from spectroscopy of the deuterium atom. Alternatively, the neutron mass can be derived from the Q-value of the beta decay of the neutron, but the Penning-trap method gives the most accurate value.

Practical Applications and Why It Matters

The precise masses of the proton and neutron are not just academic trivia. They are used in:

  • Nuclear physics: Calculating binding energies, predicting nuclear stability, and understanding fission and fusion.
  • Astrophysics: Modeling neutron stars, where the mass of a neutron determines the maximum mass of a star before it collapses into a black hole.
  • Chemistry: Isotopic masses and atomic weights are based on the proton and neutron masses.
  • Fundamental physics: Testing the Standard Model and searching for new physics by comparing precise mass measurements with theoretical predictions.

The mass difference between proton and neutron also determines whether a nucleus is stable. For example, in beta-minus decay, a neutron converts to a proton, releasing energy if the daughter nucleus is more tightly bound. The 1.29 MeV mass difference is the energy budget for this process.

Frequently Asked Questions

Which is heavier, a neutron or a proton?

A neutron is heavier than a proton by about 0.001388 u, or 1.29 MeV/c². In kilograms, the difference is about 2.3 × 10−30 kg. This is roughly 0.14% of the proton’s mass.

Why is the neutron heavier if it has no charge?

The mass comes from the quarks and their binding energy, not from electric charge. The neutron has two down quarks (each about 4.7 MeV/c²) and one up quark (about 2.2 MeV/c²), while the proton has two up and one down. The down quark is heavier, so the neutron’s quark composition gives it a slightly larger mass. The strong-force binding energy also plays a role, but the quark mass difference is the main reason.

What is the mass of a neutron in amu?

The neutron mass is 1.00866491595 u. The proton mass is 1.00727646662 u. For comparison, the electron is 0.00054857990907 u, which is about 1/1836 of the proton mass.

How much energy is released when a neutron decays into a proton?

The mass difference between a neutron and a proton plus an electron is about 0.000782 u. Converting to energy gives about 0.782 MeV. This is the maximum kinetic energy of the emitted electron (the antineutrino carries away part of the energy, so the electron’s energy varies).

Is the mass of a proton exactly 1 u?

No. The atomic mass unit is defined as 1/12 of a carbon-12 atom, which includes electrons and binding energy. A proton is slightly heavier than 1 u (1.00728 u) because the carbon-12 atom has a mass defect from its nuclear binding energy. The proton mass is close to 1 u but not exactly.

Why do we use MeV/c² as a mass unit?

In particle physics, masses are so small that kilograms are unwieldy. Since mass and energy are equivalent, physicists use energy units divided by c². This is convenient because in calculations, the c² cancels out, and you can work directly with energies. For example, the proton mass is 938.272 MeV/c², which means that if all its mass were converted to energy, it would yield 938.272 MeV.

Related

Formula used
in m | Mass deficit | u | 0.002388 | 0
in mm | Mass number (A) | - | 4 | 1
out be | Binding energy per nucleon | MeV/nucleon | (m * 931.49410242) / mm | 3

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →