molecalculator

Moles & Molar Mass

Mass of Proton, Neutron & Electron (GCSE)

Calculator No. 01-8367 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The approximate masses of the subatomic particles you need for GCSE chemistry are: proton = 1 atomic mass unit (amu), neutron = 1 amu, and electron = 1/1836 amu (often rounded to 0). These values are used to calculate the mass number of an atom, which is simply the total number of protons and neutrons in the nucleus.

Formula

For GCSE-level work, the key formula is:

Mass number (A) = Number of protons (Z) + Number of neutrons (N)

Where:

  • Mass number (A) – the total number of protons and neutrons in the nucleus (no unit, or sometimes called “nucleon number”).
  • Number of protons (Z) – also called the atomic number; this defines the element.
  • Number of neutrons (N) – found by subtracting the atomic number from the mass number.

The actual masses in kilograms are:

  • Proton: 1.6726219 × 10−27 kg
  • Neutron: 1.6749275 × 10−27 kg
  • Electron: 9.1093837 × 10−31 kg

Because these numbers are so tiny, chemists use the atomic mass unit (amu or u), where 1 amu = 1.660539 × 10−27 kg. In that scale, the proton is 1.00728 amu, the neutron is 1.00867 amu, and the electron is 0.000549 amu. For GCSE, you round them to 1, 1, and 0.

Worked Example

Take a carbon-12 atom. It has 6 protons and 6 neutrons.

Mass number = 6 + 6 = 12

Now take a sodium atom with atomic number 11 and mass number 23. Number of neutrons = 23 − 11 = 12.

For an electron, compare its mass to a proton: 0.000549 / 1.00728 ≈ 1/1836. So the electron is about 1836 times lighter than a proton. In most GCSE calculations, you ignore the electron’s mass entirely because it is so small.

Assumptions

  • You are using the rounded GCSE values: proton = 1, neutron = 1, electron = 0.
  • The atom is neutral (equal numbers of protons and electrons) unless stated otherwise.
  • You are not dealing with isotopes that have unusual mass defects – those are beyond GCSE.
  • You are calculating the mass number, not the relative atomic mass (which considers isotope abundance).

Why the Electron’s Mass Is Ignored

In chemistry, the electron is so light that it contributes virtually nothing to the atom’s mass. If you were to weigh a carbon atom, the electrons would add only about 0.03% of the total mass. That is why the mass number is just protons + neutrons. This simplification works because chemical reactions involve only electrons – they are transferred or shared – but the nucleus stays intact. The mass of an atom is essentially the mass of its nucleus.

The electron’s mass does matter in physics, especially when calculating the energy of electron transitions or in particle physics, but for GCSE chemistry, you can safely treat it as zero.

Relative Atomic Mass vs. Mass Number

A common confusion is between mass number and relative atomic mass (Ar). The mass number is a whole number for one specific isotope. The relative atomic mass is the weighted average of all naturally occurring isotopes of an element. For example, chlorine has two isotopes: chlorine-35 (about 75%) and chlorine-37 (about 25%). The relative atomic mass is about 35.5, not a whole number. On the periodic table, you see Ar values like 35.5 for chlorine, but the mass number of any single chlorine atom is either 35 or 37.

For GCSE calculations, you use the mass number when working out the number of neutrons in a specific isotope. You use the relative atomic mass when calculating relative formula mass or reacting masses.

Common Mistakes and How to Avoid Them

  • Mixing up protons and neutrons: The atomic number (protons) defines the element. If you change the number of protons, you get a different element. Changing neutrons gives an isotope.
  • Forgetting that electrons are not in the nucleus: The mass number counts only protons and neutrons. Electrons are outside the nucleus.
  • Using the wrong units: Mass number has no unit; it is a count. Relative atomic mass is also unitless, but it is a weighted average, not a count.
  • Rounding too early: When using actual masses, keep at least 3 significant figures until the final step. For GCSE, the rounded values are fine, but if a question gives you exact masses, use them.
  • Confusing “mass number” with “atomic mass” on the periodic table: The periodic table shows relative atomic mass, not mass number. For most elements, the mass number of the most common isotope is close to the relative atomic mass, but not always (e.g., chlorine).

How to Use These Masses in Calculations

At GCSE, you will need to:

  1. Find the number of protons, neutrons, and electrons in an atom or ion.
  2. Calculate the relative formula mass (Mr) of a compound by adding the relative atomic masses of its atoms.
  3. Use the mass number to write nuclear symbols, e.g., 23Na for sodium-23.

For example, to find the number of neutrons in an oxygen atom with mass number 16 and atomic number 8: neutrons = 16 − 8 = 8. For an ion like O2−, the number of electrons is 8 + 2 = 10, but the mass number does not change because electrons have negligible mass.

When calculating relative formula mass, you add the Ar values from the periodic table. For water, H2O: (2 × 1) + 16 = 18. This uses the relative atomic masses, not the mass numbers of individual isotopes.

Frequently Asked Questions

What is the exact mass of a proton in kg?

The exact mass of a proton is 1.6726219 × 10−27 kg. For GCSE, you round this to 1 atomic mass unit (amu), which is about 1.66 × 10−27 kg. You will rarely need the kilogram value in chemistry – it appears more in physics.

Why is the electron mass given as 0 in the periodic table?

Because the electron is roughly 1836 times lighter than a proton, its mass is so small that it does not affect the mass number. When you round to whole numbers, the electron contributes 0. For example, a carbon-12 atom has 6 protons and 6 neutrons, giving a mass number of 12; the 6 electrons add only about 0.0033 amu, which is negligible.

Does the mass of an atom change when it gains or loses electrons?

Technically yes, but so little that it is undetectable in normal chemistry. An atom that gains an electron becomes a negative ion; its mass increases by about 0.0005 amu per electron. That is far too small to affect any GCSE calculation. The mass number stays the same because it only counts protons and neutrons.

What is the difference between mass number and relative atomic mass?

Mass number is the total number of protons and neutrons in one specific isotope – it is always a whole number. Relative atomic mass is the weighted average of the masses of all naturally occurring isotopes of an element, compared to 1/12 of a carbon-12 atom. It can be a decimal, like 35.5 for chlorine.

How do I calculate the number of neutrons if I only know the mass number and atomic number?

Subtract the atomic number (protons) from the mass number. For example, if an atom has mass number 56 and atomic number 26, it has 56 − 26 = 30 neutrons. This works for any neutral atom or ion, because the mass number only counts protons and neutrons.

Is the neutron heavier than the proton?

Yes, but only by a tiny amount. The neutron is about 0.0014 amu heavier than the proton. In kilograms, that is about 2.3 × 10−30 kg. For GCSE, you treat them as equal (both 1 amu). The difference matters in nuclear physics but not in school chemistry.

Related

Formula used
in m | Mass of solute | g | 2.922 | 0
in mm | Molar mass | g/mol | 58.44 | 0.001
in v | Final solution volume | mL | 250 | 0.001
out c | Molarity | mol/L | m / mm / (v / 1000) | 4
out cmm | Concentration in millimolar | mM | c * 1000 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →