molecalculator

Moles & Molar Mass

Mn Atomic Number & Electron Configuration

Calculator No. 01-9699 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Manganese (Mn) has an atomic number of 25, meaning every manganese atom contains 25 protons in its nucleus. Its ground-state electron configuration is 1s2 2s2 2p6 3s2 3p6 3d5 4s2, often abbreviated as [Ar] 3d5 4s2.

Formula

The electron configuration is built by filling atomic orbitals in order of increasing energy, following the aufbau principle. The order of orbital filling is:

  1. 1s, 2s, 2p, 3s, 3p, 4s, 3d, 4p, 5s, 4d, 5p, 6s, 4f, 5d, 6p, 7s, 5f, 6d, 7p

Each orbital type has a maximum electron capacity: s = 2, p = 6, d = 10, f = 14. Electrons are added one by one to the lowest-energy available orbital. For manganese (Z = 25), the first 18 electrons fill the argon core (1s2 2s2 2p6 3s2 3p6), then the 4s orbital (2 electrons) fills before the 3d orbital (5 electrons) because 4s is slightly lower in energy for neutral atoms. The full configuration is therefore 1s2 2s2 2p6 3s2 3p6 3d5 4s2.

Worked Example

For manganese (Z = 25):

  1. Fill 1s: 2 electrons (total 2)
  2. Fill 2s: 2 electrons (total 4)
  3. Fill 2p: 6 electrons (total 10)
  4. Fill 3s: 2 electrons (total 12)
  5. Fill 3p: 6 electrons (total 18)
  6. Fill 4s: 2 electrons (total 20)
  7. Fill 3d: 5 electrons (total 25)

Result: 1s2 2s2 2p6 3s2 3p6 3d5 4s2. The calculator above reproduces this for Z = 25.

Assumptions

  • The configuration is for a neutral, ground-state atom.
  • The aufbau principle applies; exceptions exist for some transition metals (e.g., chromium, copper) where a half-filled or fully filled d subshell is favored.
  • For ions, electrons are removed from the highest-energy orbital first (for transition metals, 4s before 3d).

Why Manganese’s Configuration Matters

The 3d5 4s2 arrangement is special because the 3d subshell is exactly half-filled (5 electrons in 5 orbitals). Half-filled subshells have extra stability due to exchange energy and reduced electron-electron repulsion. This explains why manganese commonly forms +2 (losing the two 4s electrons) and +7 (losing all seven valence electrons) oxidation states, the latter seen in permanganate (MnO4−). The half-filled d shell also gives manganese its paramagnetic properties and its role as an essential trace element in enzymes like superoxide dismutase.

How to Read the Configuration

The notation lists subshells in order of increasing energy. The superscripts are the number of electrons in each subshell. The sum of all superscripts equals the atomic number (25). The noble-gas shorthand [Ar] replaces the 18 electrons of argon (1s2 2s2 2p6 3s2 3p6), leaving only the valence electrons visible: 3d5 4s2. This shorthand is useful because valence electrons determine chemical behavior.

Common Mistakes and Misconceptions

  • Wrong order: Some write 3d before 4s. For neutral atoms, 4s fills first, but for ions, 4s empties first. Always write the configuration in the standard order (1s, 2s, 2p, … 3d, 4s) for neutral atoms.
  • Counting electrons: A common error is miscounting the d electrons. For Mn, 3d5 means 5 electrons, not 3. Double-check the superscripts sum to 25.
  • Assuming all transition metals are exceptions: Only a few (Cr, Cu, Mo, Ag, Au, etc.) deviate from the aufbau rule. Manganese does not.

Related Properties

Manganese is a hard, brittle, silvery metal. Its electron configuration leads to several notable properties:

  • Oxidation states: Mn exhibits oxidation states from +2 to +7, with +2 (Mn2+, d5) and +7 (Mn7+, d0) being most common.
  • Color: The d5 configuration gives Mn2+ compounds a pale pink color, while permanganate (MnO4−) is deep purple.
  • Magnetism: With five unpaired d electrons, Mn2+ is highly paramagnetic.

Frequently Asked Questions

Why is the 4s orbital filled before 3d?

For neutral atoms, the 4s orbital is slightly lower in energy than 3d, so it fills first. This is a consequence of electron shielding and penetration. However, once electrons are added, the 3d orbitals drop in energy, so for transition metal ions, the 4s electrons are removed first.

What is the electron configuration of Mn2+?

For Mn2+, remove the two 4s electrons first: [Ar] 3d5. The five 3d electrons remain, giving a half-filled d shell, which is particularly stable.

Is manganese an exception to the aufbau principle?

No. Manganese follows the predicted order exactly. The exceptions are chromium ([Ar] 3d5 4s1) and copper ([Ar] 3d10 4s1), where a half-filled or filled d subshell is favored over a filled 4s.

How many unpaired electrons does manganese have?

In its ground state, manganese has five unpaired electrons in the 3d subshell (one in each d orbital). This makes it paramagnetic. In Mn2+, it also has five unpaired electrons.

What is the valence electron configuration of manganese?

The valence electrons are those in the highest energy level, which for Mn are the 4s2 electrons. However, chemists often consider the 3d electrons as part of the valence shell because they participate in bonding. Thus, the valence configuration is often written as 3d5 4s2.

Related

Formula used
in z | Atomic number Z | - | 25 | 1 | 118
out ec | Electron configuration (full) | - | ec_full(z) | 0
out ecs | Electron configuration (noble-gas core) | - | ec_short(z) | 0
out shell | Electron count by shell (K, L, M, N, O, P) | - | shell_count(z) | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →