molecalculator

Moles & Molar Mass

Molar Mass of Glucose (C6H12O6)

Calculator No. 01-9885 · Updated · Formula and assumptions shown below

Molarity 0.0649 mol/L
Concentration in millimolar
64.88 mM
= Molarity × 1000
Mass of solute
2.922 g
Set in the form below
Molar mass
180.156 g/mol
Set in the form below
You enter
Mass of solute (g), Molar mass (g/mol), Final solution volume (mL)
You get
Molarity (mol/L), Concentration in millimolar (mM)
Rounding
4 dp · 2 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The molar mass of glucose (C6H12O6) is 180.156 g/mol. This is the mass of one mole of glucose molecules, calculated by summing the atomic weights of 6 carbon, 12 hydrogen, and 6 oxygen atoms. You can use the calculator below to find the molar mass of any simple sugar by entering its formula mass or by adjusting the atomic weights if you are working with a specific isotope.

Formula

The molar mass (M) of a compound is the sum of the atomic masses of all atoms in its molecular formula:

M = (nC × AC) + (nH × AH) + (nO × AO)

  • nC = number of carbon atoms (6 for glucose)
  • AC = atomic weight of carbon = 12.011 g/mol
  • nH = number of hydrogen atoms (12)
  • AH = atomic weight of hydrogen = 1.008 g/mol
  • nO = number of oxygen atoms (6)
  • AO = atomic weight of oxygen = 15.999 g/mol

The calculator above uses the same principle but for a solution: you enter the mass of glucose, its molar mass (default 180.156 g/mol), and the final volume of solution. The first output is the molarity (mol/L), which is the number of moles of glucose per liter of solution.

Worked Example

Let’s calculate the molarity when 2.922 g of glucose is dissolved in enough water to make 250 mL of solution.

  1. Convert volume to liters: 250 mL = 250 / 1000 = 0.250 L.
  2. Calculate moles of glucose: moles = mass / molar mass = 2.922 g / 180.156 g/mol = 0.01622 mol (rounded to 5 significant figures).
  3. Calculate molarity: c = moles / volume = 0.01622 mol / 0.250 L = 0.06488 mol/L.
  4. Convert to millimolar: 0.06488 mol/L × 1000 = 64.88 mM.

The calculator gives 0.0649 mol/L (rounded to 4 decimal places) and 64.88 mM. This matches the manual calculation.

Assumptions

  • The molar mass is based on the IUPAC abridged standard atomic weights (H 1.008, C 12.011, O 15.999).
  • The solution is at typical laboratory temperature (about 25 °C) – temperature does not affect molarity significantly because molarity is defined per liter of solution, not per kg of solvent.
  • Glucose is a non-electrolyte; it does not dissociate into ions in water, so 1 mole of glucose gives 1 mole of particles.
  • The final volume is used, not the volume of solvent added. This is the standard definition of molarity.

Why Molar Mass Matters for Sugars

Molar mass is the bridge between the mass of a substance you weigh on a balance and the number of molecules or moles you need for a reaction or solution. For glucose, knowing that 1 mole weighs 180.156 g lets you prepare solutions of exact concentration, which is essential in biochemistry, medicine (e.g., IV glucose solutions), and food science. For example, a 5% glucose solution (5 g per 100 mL) has a molarity of about 0.278 mol/L (5 g / 180.156 g/mol / 0.100 L). This is a common concentration for medical dextrose infusions, though you should always follow the specific protocol for any clinical use.

How to Calculate Molar Mass of Any Sugar

Simple sugars (monosaccharides) all have the general formula (CH2O)n, but they differ in structure. To find the molar mass of any sugar:

  1. Write the molecular formula (e.g., fructose is also C6H12O6, so it has the same molar mass as glucose).
  2. Look up the atomic weights: C = 12.011, H = 1.008, O = 15.999.
  3. Multiply each atomic weight by the number of atoms of that element.
  4. Sum the products.

For example, sucrose (table sugar) is C12H22O11: (12×12.011) + (22×1.008) + (11×15.999) = 342.296 g/mol. Glucose and fructose are isomers, so they share the same molar mass of 180.156 g/mol.

Common Mistakes and Misconceptions

  • Confusing molar mass with molecular weight in daltons. Numerically they are the same, but molar mass has units of g/mol while molecular weight is dimensionless (or in daltons).
  • Using the wrong atomic weight. Some sources round carbon to 12.01, hydrogen to 1.01, oxygen to 16.00, giving 180.16 g/mol. That is fine, but be consistent.
  • Forgetting that glucose is a monomer. Starch or cellulose have much higher molar masses because they are polymers made of many glucose units. The molar mass of a polymer is an average, not a fixed number.
  • Using molarity vs. molality. Molarity is moles per liter of solution; molality is moles per kilogram of solvent. They are similar for dilute aqueous solutions but differ at higher concentrations.

Practical Uses in the Lab

In the laboratory, you often need to prepare a glucose solution of a specific molarity. For instance, to make 1 L of 1 M glucose, you would weigh out 180.156 g of glucose and dissolve it in water, then adjust the final volume to 1 L. The calculator above helps you do the reverse: given a mass and volume, find the concentration. This is useful for checking the concentration of a solution you made, or for diluting a stock solution. Always use a volumetric flask for precise work, and remember to dissolve the solute in a smaller volume of solvent first, then add solvent to the mark.

Safety and Handling

Glucose is generally non-toxic and safe to handle, but as with any chemical, follow standard laboratory safety: wear gloves and safety glasses, avoid inhaling dust, and wash hands after handling. When preparing solutions, use clean glassware and distilled or deionized water. If you are working with glucose in a biological context (e.g., cell culture), use sterile technique. Always follow your lab’s specific methods, the safety data sheet (SDS), and your supervisor’s instructions. The calculator here is for planning and educational purposes, not for clinical dosing or medical preparation.

Frequently Asked Questions

What is the molar mass of glucose in grams per mole?

It is 180.156 g/mol, based on the standard atomic weights of carbon (12.011), hydrogen (1.008), and oxygen (15.999). Some textbooks round to 180.16 g/mol, which is acceptable for most calculations.

Is the molar mass of fructose the same as glucose?

Yes, because fructose has the same molecular formula, C6H12O6. They are structural isomers, so they have identical molar masses. The difference lies in how the atoms are arranged, not in the number of each atom.

How many moles are in 50 grams of glucose?

Divide the mass by the molar mass: 50 g / 180.156 g/mol = 0.2775 mol. So 50 g of glucose contains about 0.278 moles of glucose molecules.

What is the difference between molar mass and molecular weight?

They are numerically the same for a given molecule, but molar mass is expressed in g/mol (mass per amount of substance), while molecular weight is a dimensionless ratio (or expressed in daltons). In practice, chemists use the terms interchangeably.

Why is the molar mass of glucose not a whole number?

Because atomic weights are weighted averages of naturally occurring isotopes. Carbon, for example, is mostly carbon-12 but has a small amount of carbon-13, raising its average atomic weight to 12.011. So the sum is not a whole number.

Can I use the same molar mass for glucose monohydrate?

No. Glucose monohydrate (C6H12O6·H2O) includes one water molecule per glucose, so its molar mass is 180.156 + 18.015 = 198.171 g/mol. Always check the formula of the compound you have.

Related

Formula used
in m | Mass of solute | g | 2.922 | 0
in mm | Molar mass | g/mol | 180.156 | 0.001
in v | Final solution volume | mL | 250 | 0.001
out c | Molarity | mol/L | m / mm / (v / 1000) | 4
out cmm | Concentration in millimolar | mM | c * 1000 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →