molecalculator

Moles & Molar Mass

Nitric Acid Formula and Molar Mass Calculator

Calculator No. 01-3642 · Updated · Formula and assumptions shown below

Molar mass 63.012 g/mol
Hydrogen atoms
1
Set in the form below
Nitrogen atoms
1
Set in the form below
Oxygen atoms
3
Set in the form below
You enter
Hydrogen atoms, Nitrogen atoms, Oxygen atoms
You get
Molar mass (g/mol)
Rounding
3 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Nitric acid has the chemical formula HNO3 and a molar mass of 63.012 g/mol, calculated from the standard atomic weights of hydrogen, nitrogen, and oxygen. Enter the number of atoms of each element to calculate the molar mass of a nitric-acid formula unit; the result is in grams per mole.

Formula

Molar mass is the sum of each element’s atomic weight multiplied by the number of its atoms in the chemical formula:

M = h(1.008) + n(14.007) + o(15.999)

  • M is molar mass, in g/mol.
  • h, n, and o are the counts of hydrogen, nitrogen, and oxygen atoms in one formula unit. These are counts, not masses.
  • 1.008, 14.007, and 15.999 are the abridged standard atomic weights used here for hydrogen, nitrogen, and oxygen, respectively, in g/mol.

For nitric acid, HNO3, each formula unit contains one hydrogen atom, one nitrogen atom, and three oxygen atoms. The calculator uses those counts and atomic weights to find the formula’s molar mass.

Worked Example

Using the defaults shown above:

M = (1 × 1.008) + (1 × 14.007) + (3 × 15.999)

M = 1.008 + 14.007 + 47.997 = 63.012 g/mol

Thus, the molar mass of nitric acid is 63.012 g/mol. This value is the mass of one mole of HNO3 formula units, not the mass of one molecule.

Assumptions

  • The formula entered represents a neutral chemical formula unit; this calculation does not account for ions, solvates, hydrates, or isotopic enrichment.
  • The calculation uses the listed abridged standard atomic weights and reports the result to three decimal places.
  • For bench work, follow your lab method, the safety data sheet (SDS), and your supervisor.

What the Formula Means

HNO3 is the molecular formula for nitric acid. The subscript 3 applies only to oxygen, so it means three oxygen atoms; the lack of a subscript after hydrogen or nitrogen means one atom of each. Counting these atoms is the key step in calculating molar mass. A common mistake is to multiply the nitrogen weight by three or to treat the 3 as applying to the whole formula.

“Molar mass” describes mass per amount of substance. A mole contains exactly 6.02214076 × 1023 elementary entities, so one mole of HNO3 formula units has a mass of about 63.012 g. The same numerical value can be expressed as 63.012 Da for the average molecular mass of one molecule, but the units and meaning differ: g/mol refers to a mole, while Da refers to an individual molecule’s mass on the atomic-mass scale.

Atomic weights are averages reflecting naturally occurring isotopic abundances. Consequently, the calculated molar mass is a conventional average, not a claim that every nitric acid molecule has precisely the same mass. A sample enriched in a particular isotope can have a different molar mass.

Using Molar Mass in Calculations

Molar mass connects a weighed amount to the amount in moles. For pure nitric acid, the relationship is:

amount (mol) = mass (g) ÷ molar mass (g/mol)

For example, 6.3012 g of pure HNO3 corresponds to 0.10000 mol when divided by 63.012 g/mol. Conversely, multiplying moles by molar mass gives mass. This arithmetic is useful in general chemistry and stoichiometry, but the result assumes the mass refers to pure HNO3.

Commercial nitric acid is often an aqueous solution rather than pure acid. If a label gives a mass fraction, the mass of HNO3 is only that fraction of the solution’s total mass. For instance, a 60% by-mass solution contains 0.60 g of HNO3 per gram of solution; its molar concentration cannot be determined from that percentage alone without additional information such as solution density and the volume basis. Do not treat the molar mass as the molar concentration: g/mol and mol/L are different quantities.

Common Confusions and Limits

  • Formula versus solution strength: HNO3 identifies the compound. It does not specify how much acid is present in a bottle of solution.
  • Subscripts versus coefficients: In 2 HNO3, the leading 2 counts two formula units; it does not change the molar mass of one formula unit. The total mass represented by two moles is twice the one-mole mass.
  • Rounding: A reference may show 63.01 or 63.0 g/mol because it rounds to fewer decimal places. Those values are consistent with 63.012 g/mol at the displayed precision.
  • Formula units and dissociation: Nitric acid can ionize in water, but that does not change the molar mass of the HNO3 formula used to describe the starting compound.

This calculator is a formula-based calculation, not an assay of a physical sample. It cannot determine purity, concentration, density, or the amount of water in a solution. For those questions, use the sample’s stated composition or suitable analytical data.

Frequently Asked Questions

What is the formula of nitric acid?
Its chemical formula is HNO3: one hydrogen atom, one nitrogen atom, and three oxygen atoms per formula unit.

What is the molar mass of HNO3?
Using H = 1.008, N = 14.007, and O = 15.999, the molar mass is 1.008 + 14.007 + 3(15.999) = 63.012 g/mol.

How many grams are in one mole of nitric acid?
One mole of pure HNO3 has a mass of about 63.012 g. A mole of an aqueous nitric-acid solution has a different mass because it includes water and depends on the solution’s composition.

Why do some sources give 63.01 g/mol?
That is the same calculated value rounded to two decimal places. The extra digits in 63.012 g/mol reflect the atomic weights selected for this calculation.

Is 63.012 g/mol the concentration of nitric acid?
No. It is molar mass, measured in grams per mole. Concentration describes how much solute is present in a specified amount of solution, commonly in moles per litre.

Related

Formula used
in h | Hydrogen atoms | - | 1 | 0
in n | Nitrogen atoms | - | 1 | 0
in o | Oxygen atoms | - | 3 | 0
out mm | Molar mass | g/mol | h * 1.008 + n * 14.007 + o * 15.999 | 3

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →