molecalculator

Moles & Molar Mass

Resting Caloric Rate Calculator: Formula and Limits

Calculator No. 01-2744 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

A resting caloric rate calculator estimates the calories your body uses in a day at rest, usually from age, height, weight, and sex as used by the chosen equation. Enter those details to get an estimated resting energy expenditure in kilocalories per day; it is a planning estimate, not a direct measurement or a complete daily calorie target.

Formula

This calculator uses the Mifflin–St Jeor equation, a commonly used estimate of resting energy expenditure (REE):

  • Male coefficient: REE = 10 × weight + 6.25 × height − 5 × age + 5.
  • Female coefficient: REE = 10 × weight + 6.25 × height − 5 × age − 161.

Weight (w) is entered in kilograms, height (h) in centimeters, and age (a) in completed years. The result (r) is in kilocalories per day. The selector chooses the equation coefficient: 2 uses +5, and 1 uses −161. These coefficients reflect the categories used to develop the equation; they are not a measurement of an individual’s gender identity or a complete description of biological variation. The equation uses the same numeric coefficients for the stated units, so do not enter pounds or inches without converting them first.

Worked Example

Using the calculator’s default values—70 kg, 170 cm, age 30, and the Male coefficient—the calculation is:

REE = 10 × 70 + 6.25 × 170 − 5 × 30 + 5
REE = 700 + 1062.5 − 150 + 5
REE = 1617.5 kcal/day
Rounded to the displayed whole number: 1618 kcal/day.

This is the estimated energy used over a day at rest under the equation, not a promise that the body will burn exactly that amount each day.

Assumptions

  • The result is an estimate from a population-derived equation, not a measurement of an individual’s metabolism.
  • Weight, height, and age are entered in the units shown; age is in completed years.
  • The calculator uses the conventional male or female equation coefficient. It does not adjust for body composition, pregnancy, growth, or individual medical circumstances.
  • “Resting” is an estimate of energy expenditure at rest; it is not total daily energy expenditure, which also includes movement, digestion, and other activity.

Resting Rate Versus Daily Calorie Needs

Resting caloric rate is often called basal metabolic rate (BMR), but the terms are not perfectly interchangeable. BMR refers to energy use under strict, standardized conditions after sleep and fasting, while resting energy expenditure is generally measured under less restrictive resting conditions. Everyday calculators may use “resting metabolic rate” or “resting calories” loosely. The Mifflin–St Jeor equation estimates resting needs; it does not establish a person’s exact BMR.

Total daily energy expenditure (TDEE) is higher than resting expenditure for most people because it includes activity and the energy used to digest food. A rough planning method multiplies an REE estimate by an activity factor, but choosing a factor adds uncertainty. A calculator result of 1,618 kcal/day therefore does not mean that 1,618 kcal is automatically the correct daily food intake for weight maintenance, weight loss, or weight gain.

These values are dietary energy units: one food Calorie, written with a capital C, is one kilocalorie (kcal). Thus 1,618 kcal/day is also commonly written as 1,618 Calories per day on food labels and nutrition websites.

How to Choose and Use an Estimate

Mifflin–St Jeor is a practical starting point when you know height, weight, and age. Other formulas, such as Harris–Benedict, may give a different estimate because they were developed using different data and methods. No single equation is reliably the best for every person. If a clinician or dietitian has provided a measured or individualized value, follow that guidance rather than treating a general calculator as more precise.

  • Use a recent, reasonably accurate body weight and measure height in centimeters.
  • Select the coefficient that matches the equation’s intended category; be aware that the formula does not represent every person’s body composition or physiology.
  • Use the result as a starting estimate, then interpret it with activity, goals, health status, and changes over time in mind.
  • Do not infer that small differences between two estimates are meaningful. The formula is not precise enough to justify false accuracy.

For instance, entering pounds as though they were kilograms makes weight about 2.2 times too large numerically and can inflate the result substantially. Height entered in inches instead of centimeters creates a similar unit error. Check the input labels before interpreting the answer.

Accuracy, Common Problems, and Alternatives

Equation estimates have individual error. Body composition is one reason: two people of the same age, height, and weight can have different proportions of muscle and fat, and the equation does not directly measure those proportions. Differences in health, recent weight change, and other physiological factors can also affect energy expenditure. A calculator cannot diagnose a metabolic condition.

For a more individualized assessment, indirect calorimetry estimates energy expenditure by measuring oxygen consumption and carbon dioxide production under controlled conditions. It is a measurement approach rather than another height-and-weight equation, and results depend on preparation and testing conditions. It is not necessary for everyone, but a qualified health professional may consider it when precision matters.

A common misconception is that “resting calories” are a safe minimum intake or a fixed threshold below which a person must never eat. This equation does not establish either rule. Dietary needs and appropriate goals vary; unusually low intake can be unsafe, and a personalized plan should account for health and nutritional adequacy. Seek advice from a qualified clinician or registered dietitian for concerns about weight, eating, unexplained changes, or a medical condition.

Frequently Asked Questions

What is a resting caloric rate?
It is an estimate of the energy the body uses over a day at rest. It is not the same as total daily energy expenditure, which includes activity and digestion.

Is resting metabolic rate the same as BMR?
They are closely related, but BMR is measured under more strictly standardized conditions. Many online calculators use the terms loosely and estimate resting energy expenditure rather than directly measuring either value.

How accurate is the Mifflin–St Jeor calculator?
It provides a useful population-based estimate, but it can differ from an individual’s measured resting expenditure. Treat the result as an approximation, not an exact daily requirement.

Should I eat exactly my resting calorie rate?
No. Resting expenditure does not include all the energy used during an ordinary day, and the equation does not prescribe a food intake. Personal needs depend on activity, goals, health, and other factors.

Why does another calculator give me a different answer?
It may use a different equation, different input units, or a different definition of resting expenditure. Small differences are expected; compare methods and units rather than assuming one output is exact.

Related

Formula used
in w | Weight | kg | 70 | 0
in h | Height | cm | 170 | 0
in a | Age | years | 30 | 0
sel s | Equation sex coefficient | Female=1, Male=2
out r | Resting caloric rate | kcal/day | 10 * w + 6.25 * h - 5 * a + 5 - 161 * (2 - s) | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →