molecalculator

Moles & Molar Mass

Molecular Geometry of Ethanol: Shape & Bond Angles

Calculator No. 01-8977 · Updated · Formula and assumptions shown below

Molarity 0.2000 mol/L
Concentration in millimolar
200.00 mM
= Molarity × 1000
Mass of solute
2.922 g
Set in the form below
Molar mass
58.44 g/mol
Set in the form below
You enter
Mass of solute (g), Molar mass (g/mol), Final solution volume (mL)
You get
Molarity (mol/L), Concentration in millimolar (mM)
Rounding
4 dp · 2 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Ethanol (C2H5OH) has a molecular geometry that is tetrahedral around each carbon atom and bent around the oxygen atom. The carbon atoms are each surrounded by four electron groups, giving bond angles of approximately 109.5°, while the oxygen atom has two bonding pairs and two lone pairs, resulting in a bent shape with a bond angle of about 104.5°.

Formula

The calculator above computes the molarity of a solution made by dissolving a known mass of a solute (like ethanol, if you were preparing an aqueous ethanol solution) in a final volume. The formula is:

c = m / (M × V)

Where:

  • c = molarity (mol/L)
  • m = mass of solute (g)
  • M = molar mass of solute (g/mol)
  • V = final solution volume (L)

Note that the volume input is in milliliters, so it is converted to liters by dividing by 1000. The molar mass for ethanol is 46.07 g/mol (C: 2 × 12.011 + H: 6 × 1.008 + O: 15.999).

Worked Example

Using the default values from the calculator (mass = 2.922 g, molar mass = 58.44 g/mol, volume = 250 mL):

  1. Convert volume to liters: 250 mL ÷ 1000 = 0.250 L
  2. Calculate moles of solute: 2.922 g ÷ 58.44 g/mol = 0.05000 mol
  3. Divide moles by volume: 0.05000 mol ÷ 0.250 L = 0.2000 mol/L

The calculator shows 0.2000 mol/L (or 200.0 mM). This example uses sodium chloride (NaCl, molar mass 58.44 g/mol) as the default solute, but the same arithmetic applies to ethanol if you enter its molar mass.

Assumptions

  • The solute is pure and completely dissolves without chemical reaction.
  • The final volume is measured after dissolution, not the solvent volume added.
  • Temperature is assumed to be 25 °C; molarity changes slightly with temperature due to volume expansion.
  • For ethanol, the solution is assumed to be dilute enough that volumes are additive (ethanol-water mixtures contract, so this is an approximation).

Why Ethanol’s Geometry Matters

Ethanol’s geometry explains its physical properties and reactivity. The tetrahedral carbons give the molecule a three-dimensional shape that is not flat. The bent oxygen with lone pairs creates a polar O–H bond and a polar C–O bond, making ethanol miscible with water. The shape also affects how ethanol packs in liquid form, contributing to its relatively low boiling point (78.37 °C) compared to water (100 °C) despite having a similar molar mass.

The lone pairs on oxygen are crucial for hydrogen bonding. Ethanol can donate a hydrogen bond (through the O–H) and accept one (through the lone pairs), which is why it mixes with water in all proportions. This hydrogen bonding also makes ethanol a good solvent for many polar and nonpolar compounds, a property directly tied to its molecular shape.

How to Determine the Geometry Yourself

You can predict ethanol’s geometry using VSEPR (Valence Shell Electron Pair Repulsion) theory:

  1. Draw the Lewis structure: CH3–CH2–OH. Each carbon has four single bonds (no lone pairs). Oxygen has two single bonds and two lone pairs.
  2. Count electron groups around each central atom. A single bond, double bond, triple bond, or lone pair each counts as one electron group.
  3. For carbon: 4 electron groups → tetrahedral electron-pair geometry → tetrahedral molecular geometry (since no lone pairs). Bond angle ≈ 109.5°.
  4. For oxygen: 4 electron groups (2 bonds + 2 lone pairs) → tetrahedral electron-pair geometry, but the molecular geometry is described as bent (or V-shaped) because lone pairs are not counted in the molecular shape. Bond angle ≈ 104.5° (slightly less than 109.5° because lone pairs repel more strongly than bonding pairs).

This method works for any small molecule. For ethanol, the two carbons are not identical: the CH3 carbon is bonded to three hydrogens and one carbon, while the CH2 carbon is bonded to two hydrogens, one carbon, and one oxygen. Both are tetrahedral, but the C–C–O bond angle may be slightly distorted from ideal due to the electronegativity of oxygen.

Common Misconceptions: Is Ethanol Linear or Planar?

One common mistake is thinking that because ethanol has a chain of three atoms (C–C–O), it is linear. It is not. The tetrahedral geometry around each carbon means the chain is zigzagged in three dimensions. Another misconception is that the O–H bond is at a 180° angle to the C–O bond; in reality, the C–O–H angle is about 108.9° (close to tetrahedral).

Also, ethanol is not planar. The carbon atoms are sp3 hybridized, meaning the molecule has a three-dimensional structure. This is why ethanol has conformational isomers (staggered vs. eclipsed) when you rotate around the C–C bond. The most stable conformation is the anti conformation, where the OH group is as far as possible from the methyl group.

Comparing Ethanol to Other Small Alcohols

Ethanol’s geometry is typical of alcohols. Methanol (CH3OH) has a tetrahedral carbon and a bent oxygen, just like ethanol, but with a shorter carbon chain. Isopropanol (C3H8O) has a central carbon bonded to two methyl groups and an OH group; that central carbon is tetrahedral, but the molecule is more branched. The key difference is that the bond angles around oxygen remain close to 104.5° in all alcohols because the lone pairs are always there.

Compare this to dimethyl ether (CH3–O–CH3), a constitutional isomer of ethanol. The oxygen in dimethyl ether also has two lone pairs and two bonding pairs, so it is bent, but the C–O–C angle is about 111.7° (larger than in ethanol because the bulky methyl groups repel each other). This shape difference explains why dimethyl ether is a gas at room temperature while ethanol is a liquid—the lack of an O–H group means no hydrogen bonding.

Practical Relevance: Solubility and Boiling Point

The bent geometry around oxygen creates a dipole moment of about 1.69 debye for ethanol. This dipole, combined with hydrogen bonding, makes ethanol a polar protic solvent. It dissolves ionic compounds (like NaCl) moderately well, but not as well as water because the nonpolar ethyl group interrupts the hydrogen-bonding network.

The boiling point of ethanol (78.37 °C) is higher than that of propane (a similar-sized nonpolar molecule, -42.1 °C) because of hydrogen bonding. But it is lower than water (100 °C) because ethanol has only one O–H group per molecule, while water has two. This is a direct consequence of the molecular shape and the number of hydrogen-bonding sites.

Frequently Asked Questions

What is the exact bond angle in ethanol?

The H–C–H bond angles around each carbon are approximately 109.5° (ideal tetrahedral). The C–O–H bond angle is about 108.9° (measured by microwave spectroscopy), and the H–O–H angle (if you consider the lone pairs) is not directly measured, but the H–O–C angle is about 108.9°. The O–C–C angle is about 110.3°.

Is ethanol polar or nonpolar?

Ethanol is polar. The O–H bond is highly polar (oxygen is much more electronegative than hydrogen), and the C–O bond is also polar. The molecule has a net dipole moment of about 1.69 D, pointing roughly from the hydroxyl hydrogen toward the oxygen. The ethyl group is nonpolar, but the overall molecule is polar enough to be miscible with water.

Why does ethanol have a bent shape around oxygen?

According to VSEPR theory, the oxygen atom has four electron groups: two bonding pairs (to carbon and hydrogen) and two lone pairs. These four groups repel each other and arrange tetrahedrally (109.5°). Since lone pairs occupy more space than bonding pairs, they compress the bond angle to about 104.5° (similar to water’s 104.5°).

Does ethanol have resonance structures?

No, ethanol does not have resonance structures. All bonds are single bonds, and there are no pi bonds or lone pairs that can be delocalized. The Lewis structure is fixed: CH3–CH2–O–H. The only structural variation is conformational (rotation around the C–C bond), not resonance.

How does ethanol’s geometry affect its reactivity?

The tetrahedral carbons are relatively unreactive, but the oxygen’s lone pairs make it a nucleophile and a base. The O–H bond is acidic enough to be deprotonated by strong bases (pKa ≈ 16). The bent geometry allows the oxygen to act as a hydrogen-bond acceptor, which is key in many enzymatic reactions involving ethanol, such as its oxidation to acetaldehyde by alcohol dehydrogenase.

Related

Formula used
in m | Mass of solute | g | 2.922 | 0
in mm | Molar mass | g/mol | 58.44 | 0.001
in v | Final solution volume | mL | 250 | 0.001
out c | Molarity | mol/L | m / mm / (v / 1000) | 4
out cmm | Concentration in millimolar | mM | c * 1000 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →