molecalculator

Moles & Molar Mass

RV Propane Usage Calculator: How to Estimate

Calculator No. 01-11618 · Updated · Formula and assumptions shown below

Estimated runtime 57.3 hours
Estimated runtime
2.4 days
= Estimated runtime ÷ 24
Tank capacity
20 lb
Set in the form below
Appliance 1 BTU/hr
30000 BTU/h
Set in the form below
You enter
Tank capacity (lb), Appliance 1 BTU/hr (BTU/h), Appliance 1 duty cycle (%), Appliance 2 BTU/hr (BTU/h), Appliance 2 duty cycle (%)
You get
Estimated runtime (hours), Estimated runtime (days)
Rounding
1 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

This calculator estimates how long a propane tank will last in an RV based on the tank size and the total BTU/hour draw of the appliances you are running. You enter the tank capacity in pounds or gallons, the appliance BTU ratings, and an estimated duty cycle (how often each appliance is actually on), and the calculator returns the approximate number of hours and days the propane supply will last.

Formula

The calculator uses the standard energy content of propane: one pound of propane contains approximately 21,500 BTU of heat energy when burned. The total consumption rate is the sum of each appliance’s rated BTU/hour multiplied by its duty cycle (as a fraction). The formula is:

Runtime (hours) = (Tank capacity in lb × 21,500 BTU/lb) / (Σ (Appliance BTU/hr × Duty cycle fraction))

Where:

  • Tank capacity (p) – the propane tank’s water capacity in pounds (common RV sizes: 20 lb, 30 lb, 40 lb).
  • Appliance BTU/hr (b1, b2) – the rated heat input of each propane appliance (furnace, water heater, stove, refrigerator).
  • Duty cycle (d1, d2) – the percentage of time the appliance actually runs (e.g., 25% means it runs 15 minutes per hour).
  • 21,500 BTU/lb – the approximate heat content of propane (varies slightly with temperature and purity).

If you know the tank size in gallons instead of pounds, multiply gallons by 4.24 to get pounds (since propane weighs about 4.24 lb per gallon at 60°F).

Worked Example

Using the default values: a 20 lb tank, a furnace rated at 30,000 BTU/hr running 25% of the time, and a second appliance (e.g., a water heater) at 0 BTU/hr (off).

Step 1: Convert duty cycle to a fraction: 25% = 0.25.

Step 2: Calculate the average consumption rate: 30,000 BTU/hr × 0.25 = 7,500 BTU/hr.

Step 3: Total energy in tank: 20 lb × 21,500 BTU/lb = 430,000 BTU.

Step 4: Runtime = 430,000 BTU ÷ 7,500 BTU/hr = 57.33 hours ≈ 57.3 hours.

Step 5: In days: 57.33 ÷ 24 = 2.39 days ≈ 2.4 days.

The calculator shows 57.3 hours and 2.4 days, matching this result.

Assumptions

  • Propane is 100% vaporized and burned completely; real appliances are 70–90% efficient, so actual runtime may be shorter.
  • Duty cycles are estimates; actual usage depends on thermostat settings, outdoor temperature, and habits.
  • The tank is filled to its rated capacity (a 20 lb tank holds 20 lb of propane when full, not 20 lb of water).
  • No other appliances are running; if you run a stove or grill, add their BTU ratings and duty cycles.
  • Ambient temperature is moderate; in freezing weather, propane vaporization slows and the tank may not deliver full BTU output.

How to Use This Calculator

To get a realistic estimate, you need to know the BTU ratings of your RV appliances. These are usually printed on a label near the appliance or in the owner’s manual. Common values:

  • Furnace: 20,000–40,000 BTU/hr
  • Water heater: 10,000–12,000 BTU/hr
  • Cooktop burner (per burner): 6,000–10,000 BTU/hr
  • Refrigerator (propane mode): 1,500–3,000 BTU/hr

Set the duty cycle based on how often each runs. For example, a furnace in mild weather might run 20% of the time; in cold weather, it could run 60% or more. A water heater cycles on to maintain temperature, often 10–20% of the time. A stove burner runs only while cooking.

The result is a planning estimate, not a guarantee. Keep a spare tank or know where to refill if you are close to the limit.

Choosing the Right Tank Size

RV propane tanks come in common sizes: 20 lb (the standard BBQ-style tank), 30 lb, and 40 lb. Larger tanks are heavier and take up more space but allow longer boondocking trips. To choose:

  • Calculate your daily BTU usage: sum (appliance BTU/hr × duty cycle) for a typical day.
  • Multiply by the number of days you plan to be off-grid.
  • Divide by 21,500 BTU/lb to get pounds needed.
  • Add a 20% safety margin for cold weather and inefficiency.

For example, if you use 50,000 BTU/day and want 10 days, you need 500,000 BTU ÷ 21,500 ≈ 23.3 lb, so a 30 lb tank is a safe choice.

Common Mistakes and How to Avoid Them

  • Mixing pounds and gallons: Always convert to pounds. One gallon of propane weighs about 4.24 lb, not 8 lb (that’s water).
  • Ignoring duty cycle: Running a 30,000 BTU furnace continuously would drain a 20 lb tank in about 14 hours, but real furnaces cycle on and off, so the actual usage is much lower.
  • Using the tank’s water capacity: A 20 lb tank is rated to hold 20 lb of propane, not 20 lb of water. The water capacity is about 47.6 lb, but the propane fill is limited to 80% of that.
  • Rounding too early: Keep intermediate values to at least three significant figures to avoid large errors in the final estimate.
  • Forgetting other appliances: A water heater running while the furnace is on adds to consumption. Add all active appliances.

Safety and Practical Tips

Propane is heavier than air, so leaks can pool in low areas like the RV’s basement. Install a propane detector and check connections regularly with soapy water (bubbles indicate a leak). Always turn off the propane supply at the tank when the RV is in motion or when not in use.

In cold weather, propane vaporization slows because the liquid in the tank cools as it boils. This can cause the tank to “freeze up” and deliver less gas than expected. Keep the tank as warm as possible (but never use an open flame to heat it) and consider a larger tank or a propane regulator designed for cold climates.

If you run out of propane, do not attempt to refill a tank that is not certified. Use a licensed propane dealer. Never store propane tanks inside the living area of the RV; they should be mounted on the tongue or in a ventilated compartment.

Frequently Asked Questions

How long will a 20 lb propane tank last in an RV?

It depends on usage. With a typical furnace running 25% of the time (30,000 BTU/hr), a 20 lb tank lasts about 57 hours, or roughly 2.4 days. If you only use a stove for cooking (one burner at 8,000 BTU/hr for 1 hour a day), a tank could last over 100 days. The calculator above gives a personalized estimate.

How many BTUs are in a gallon of propane?

One gallon of propane contains about 91,500 BTU. Since a gallon weighs about 4.24 lb, this works out to about 21,580 BTU per pound, which matches the 21,500 used in this calculator.

Can I use the tank’s water capacity to estimate propane?

No. A 20 lb propane tank has a water capacity of about 47.6 lb, but it is filled to only 80% of that volume with propane, giving about 20 lb of propane. Always use the propane capacity (in pounds) for calculations.

How accurate is this calculator?

It is accurate to within about 10–20% in ideal conditions. Real-world factors like appliance efficiency, wind, thermostat settings, and propane vaporization rates reduce the actual runtime. Use the result as a conservative planning tool, and always carry extra fuel if you are far from a refill station.

What does duty cycle mean in this context?

Duty cycle is the fraction of time an appliance is actually running. For example, a furnace that runs for 15 minutes every hour has a 25% duty cycle. You estimate this based on your thermostat, weather, and habits. The calculator multiplies the BTU rating by this fraction to get average consumption.

How do I convert my tank size from gallons to pounds?

Multiply the number of gallons by 4.24. For example, a 5-gallon tank holds about 21.2 lb of propane. This conversion is built into the calculator if you prefer to enter gallons, but you must convert manually before entering the value.

Alternatives to Propane

Some RVers use electric appliances (space heaters, electric water heaters) when plugged into shore power, which eliminates propane usage entirely. Others install diesel heaters, which use the vehicle’s fuel tank. Solar panels and battery systems can power small electric devices, but high-heat appliances like furnaces are rarely practical on batteries. If you want to reduce propane consumption, consider using a portable electric heater when you have hookups, and reserve propane for off-grid boondocking.

Related

Formula used
in p | Tank capacity | lb | 20 | 1 | 100
in b1 | Appliance 1 BTU/hr | BTU/h | 30000 | 0 | 200000
in d1 | Appliance 1 duty cycle | % | 25 | 0 | 100
in b2 | Appliance 2 BTU/hr | BTU/h | 0 | 0 | 200000
in d2 | Appliance 2 duty cycle | % | 0 | 0 | 100
out h | Estimated runtime | hours | (p * 21500) / (b1 * d1 / 100 + b2 * d2 / 100) | 1
out d | Estimated runtime | days | h / 24 | 1

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →