molecalculator

Moles & Molar Mass

Uranium Series Decay Chain Explained

Calculator No. 01-10338 · Updated · Formula and assumptions shown below

Fraction of original U-238 remaining 0.5000
Activity after n decays (relative)
0.5000
= (1÷2)^(Number of decays completed÷1)
Number of decays completed
1
Set in the form below
You enter
Number of decays completed
You get
Fraction of original U-238 remaining, Activity after n decays (relative)
Rounding
4 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The uranium series decay chain is the sequence of radioactive isotopes that begins with uranium-238 and ends with stable lead-206, passing through 14 intermediate decays. This article explains each step, the timescales involved, and why this chain matters for dating rocks and understanding natural radioactivity.

What Is the Uranium Series?

The uranium series (also called the uranium-radium series) is one of four natural radioactive decay chains. It starts with uranium-238 (U-238), which has a half-life of 4.468 billion years. Through a series of alpha and beta decays, it transforms into a chain of daughter isotopes, each with its own half-life, until it reaches lead-206 (Pb-206), a stable isotope. The chain includes well-known isotopes like radium-226, radon-222, and polonium-210. Because U-238 is abundant in Earth’s crust, this chain is responsible for a significant portion of natural background radiation.

How the Decay Chain Works

Each step in the chain is a nuclear transformation. An alpha decay reduces the mass number by 4 and the atomic number by 2, while a beta decay increases the atomic number by 1 without changing the mass number. The chain from U-238 to Pb-206 involves 8 alpha decays and 6 beta decays. The sequence is:

  1. U-238 → Th-234 (alpha, half-life 4.468×10⁹ years)
  2. Th-234 → Pa-234 (beta, half-life 24.1 days)
  3. Pa-234 → U-234 (beta, half-life 6.7 hours)
  4. U-234 → Th-230 (alpha, half-life 245,500 years)
  5. Th-230 → Ra-226 (alpha, half-life 75,380 years)
  6. Ra-226 → Rn-222 (alpha, half-life 1,600 years)
  7. Rn-222 → Po-218 (alpha, half-life 3.82 days)
  8. Po-218 → Pb-214 (alpha, half-life 3.10 minutes)
  9. Pb-214 → Bi-214 (beta, half-life 26.8 minutes)
  10. Bi-214 → Po-214 (beta, half-life 19.9 minutes)
  11. Po-214 → Pb-210 (alpha, half-life 164.3 microseconds)
  12. Pb-210 → Bi-210 (beta, half-life 22.3 years)
  13. Bi-210 → Po-210 (beta, half-life 5.01 days)
  14. Po-210 → Pb-206 (alpha, half-life 138.4 days)

The half-lives span from microseconds to billions of years. The long-lived parent U-238 dominates the overall decay rate; the shorter-lived daughters quickly reach a steady state called secular equilibrium.

Secular Equilibrium: The Key Concept

In a closed system that has existed for a long time (at least several half-lives of the longest-lived intermediate), the activity of each daughter equals the activity of the parent. This is secular equilibrium. For example, the activity of Ra-226 in a mineral equals the activity of U-238, even though Ra-226 is far less abundant. This is because Ra-226 decays faster, so a tiny amount produces the same number of decays per second. The ratio of atoms is inversely proportional to the half-lives: N(Ra)/N(U) = t½(Ra)/t½(U) = 1600 / 4.468×10⁹ ≈ 3.6×10⁻⁷. This equilibrium is the basis for many dating methods.

Uranium-Lead Dating and Its Uses

The U-238 to Pb-206 decay chain is the foundation of uranium-lead (U-Pb) dating, one of the most reliable geochronological tools. Because the half-life is so long, it can date rocks from hundreds of millions to billions of years old. The method works by measuring the ratio of U-238 to Pb-206 in a mineral that incorporated uranium but no lead at formation, such as zircon. The age is calculated from the decay equation: t = (1/λ) × ln(1 + Pb*/U), where λ is the decay constant (1.55125×10⁻¹⁰ per year) and Pb* is the radiogenic lead. A common check uses the ratio of Pb-207 (from U-235) to Pb-206, which gives a concordia diagram. This method has dated the oldest Earth minerals to about 4.4 billion years.

Radon and Health Concerns

Radon-222 is a noble gas produced in the chain. Because it is a gas, it can escape from rocks and soil into the air. When inhaled, radon decays into solid polonium and lead isotopes that can lodge in lung tissue, emitting alpha particles that damage DNA. Radon is the second leading cause of lung cancer after smoking. The U.S. Environmental Protection Agency recommends testing homes for radon, and if levels exceed 4 picocuries per liter (148 Bq/m³), mitigation is advised. This is a practical consequence of the uranium series decay chain.

Common Misconceptions

One misconception is that the chain ends at lead-208, which is actually the end of the thorium series (starting from Th-232). The uranium series ends at Pb-206. Another is that all intermediate isotopes are present in equal amounts; they are not—they are present in amounts proportional to their half-lives. Also, some people think that once a rock forms, the chain is immediately in equilibrium; in reality, it takes about 1 million years (roughly 10 half-lives of Th-230) for the intermediate daughters to reach equilibrium. Finally, the term “decay chain” is sometimes confused with “decay product” – a single daughter is a product, the whole sequence is the chain.

Frequently Asked Questions

What is the difference between the uranium series and the actinium series? The uranium series starts with U-238 and ends at Pb-206. The actinium series starts with U-235 and ends at Pb-207. They are separate chains with different parent isotopes and different intermediate steps.

How long does it take for uranium to decay completely? Complete decay is never achieved; it is exponential. After one half-life (4.468 billion years), half remains. After 10 half-lives (about 44.7 billion years), less than 0.1% remains, but it never reaches zero.

Why is radon a concern in basements? Radon gas seeps from soil into buildings through cracks in foundations. Basements are closer to the soil and often have lower air pressure, drawing radon in. Testing and ventilation reduce exposure.

Can the uranium series be used to date recent materials? No, because the half-life is too long; the amount of Pb-206 produced in a few thousand years is too small to measure accurately. For recent materials, carbon-14 dating (up to ~50,000 years) or uranium-thorium dating (up to ~500,000 years) is used.

What is the role of the uranium series in the Earth’s heat? The radioactive decay of U-238, U-235, and Th-232 generates about half of the Earth’s internal heat. This heat drives mantle convection, plate tectonics, and volcanic activity.

Is it safe to handle uranium minerals? Uranium minerals are weakly radioactive, but the main hazard is from radon gas and dust inhalation. Handling small samples with gloves and washing hands is generally safe, but long-term exposure or ingestion should be avoided. Always follow your lab’s safety data sheet and supervisor instructions.

Related

Formula used
in n | Number of decays completed | - | 1 | 0 | 14
out frac | Fraction of original U-238 remaining | - | (1/2)^(n/1) | 4
out activity | Activity after n decays (relative) | - | (1/2)^(n/1) | 4

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →