molecalculator

Moles & Molar Mass

Vanadium Atomic Number and Configuration

Calculator No. 01-9727 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Vanadium has the atomic number 23 and its electron configuration is [Ar] 3d3 4s2. This means a neutral vanadium atom contains 23 protons and 23 electrons, with the electrons arranged as two in the 4s subshell and three in the 3d subshell.

Formula

The atomic number Z is the number of protons in the nucleus. For a neutral atom, the number of electrons equals Z. The electron configuration is built by filling orbitals in order of increasing energy (Aufbau principle): 1s, 2s, 2p, 3s, 3p, 4s, 3d, 4p, … For vanadium (Z = 23), the filling sequence gives:

1s2 2s2 2p6 3s2 3p6 4s2 3d3

which is abbreviated as [Ar] 3d3 4s2. The shell occupancy is: K shell (n=1): 2 electrons; L shell (n=2): 8 electrons; M shell (n=3): 11 electrons (2 from 3s, 6 from 3p, 3 from 3d); N shell (n=4): 2 electrons (from 4s).

Worked Example

Using the default value Z = 23:

  • Total electrons = 23
  • Configuration: 1s2 2s2 2p6 3s2 3p6 4s2 3d3
  • Shell occupancy: K=2, L=8, M=11, N=2

Check: 2 + 8 + 11 + 2 = 23 electrons. The calculator above shows the same result for any atomic number you enter.

Assumptions

  • The configuration is for a neutral, ground-state atom.
  • The Aufbau principle and Madelung rule are applied (order of orbital filling).
  • For ions, the configuration would differ (e.g., V3+ loses 4s electrons first).

Background of Vanadium

Vanadium is a transition metal discovered in 1801 by Andrés Manuel del Río in Mexico. It was rediscovered in 1831 by Nils Gabriel Sefström, who named it after Vanadís, a Norse goddess of beauty and fertility, because of its colorful compounds. Vanadium is the 22nd most abundant element in Earth’s crust, found in about 65 different minerals, including vanadinite, carnotite, and patronite. It is never found free in nature but is extracted mainly from magnetite ores and fossil fuel deposits.

Electron Configuration Details

The electron configuration of vanadium is often a point of confusion because the 4s subshell fills before the 3d subshell. In the ground state, the 4s orbital is slightly lower in energy than the 3d, so it fills first. However, when vanadium forms cations, the 4s electrons are removed first, not the 3d. For example:

  • V2+: [Ar] 3d3
  • V3+: [Ar] 3d2
  • V4+: [Ar] 3d1
  • V5+: [Ar]

This is because the 4s electrons are farther from the nucleus and less shielded, so they are easier to remove.

Common Oxidation States and Chemistry

Vanadium exhibits oxidation states from +2 to +5, with +5 being the most common in compounds like vanadium pentoxide (V2O5). The different oxidation states produce distinct colors in aqueous solution:

  • V2+: lavender
  • V3+: green
  • V4+ (as VO2+): blue
  • V5+ (as VO2+): yellow

This color change is a classic demonstration in chemistry labs, where zinc metal reduces vanadate ions stepwise through the oxidation states.

Practical Uses and Applications

Vanadium is primarily used as an alloying agent in steel. Adding even a small amount (0.1–1%) of vanadium creates a fine-grained steel that is stronger, tougher, and more resistant to wear and fatigue. This is used in tools, engine components, and high-speed cutting tools. Vanadium redox batteries are a growing application for grid-scale energy storage, using vanadium ions in different oxidation states to store and release electricity. Vanadium compounds are also used as catalysts in the production of sulfuric acid (contact process) and in the manufacture of ceramics and pigments.

Common Misconceptions

A common mistake is to write the configuration as [Ar] 3d5 4s0 because half-filled d subshells are stable. However, for vanadium, the energy gain from a half-filled d subshell is not enough to offset the cost of emptying the 4s orbital. The actual configuration is [Ar] 3d3 4s2. Another misconception is that the 4s electrons are removed first when forming ions—this is true, but some students incorrectly remove 3d electrons first. Always remove from the highest principal quantum number (n) first.

Frequently Asked Questions

Why is vanadium’s configuration not [Ar] 3d5?

Because the energy required to promote an electron from 4s to 3d is greater than the stability gained from a half-filled d subshell. The 4s orbital is lower in energy than 3d in the neutral atom, so it fills first. The half-filled d configuration is only favorable for chromium and molybdenum, where the energy difference is smaller.

How many valence electrons does vanadium have?

Vanadium has 5 valence electrons: 2 in the 4s subshell and 3 in the 3d subshell. All five can participate in bonding, which is why vanadium commonly shows a +5 oxidation state.

What is the electron configuration of V5+?

V5+ has lost all five valence electrons, leaving the configuration [Ar]. It has no 3d or 4s electrons, which makes it a small, highly charged ion that acts as a strong oxidizing agent.

Is vanadium a metal or nonmetal?

Vanadium is a transition metal. It is hard, silvery-grey, and has good corrosion resistance. It conducts electricity and heat, though less efficiently than copper or aluminum.

Why is vanadium used in batteries?

Vanadium redox flow batteries use vanadium ions in different oxidation states (V2+/V3+ and V4+/V5+) in separate tanks. The advantage is that the electrolyte can be recharged by replacing the liquid, and the battery has a long cycle life because there is no solid electrode degradation.

For lab work involving vanadium compounds, always follow your lab method, the safety data sheet (SDS) and your supervisor. Vanadium pentoxide is toxic and should be handled with care.

Related

Formula used
in z | Atomic number Z | - | 23 | 1 | 118
out e | Total electrons | - | z | 0
out cfg | Electron configuration (ground state) | - | 0 | 0
out shell | Shell occupancy (K, L, M, N) | - | 0 | 0

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →