molecalculator

Moles & Molar Mass

WCA Calculator Online: How to Use It

Calculator No. 01-9444 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The WCA (World Cube Association) online calculator is a tool for converting official Rubik’s Cube and other twisty-puzzle competition results between different timing formats, most commonly from a single solve time in seconds to a “Mean of 3” or “Average of 5” result. You enter your individual solve times, and it returns the official average or mean that would be recorded for a competition, applying the WCA’s specific rules for trimming the best and worst times. This page explains how that calculation works, how to use such a calculator correctly, and the common mistakes that trip up new competitors.

Formula

The WCA uses two distinct ways to combine solve times, and they are not interchangeable.

Average of 5 (Ao5): This is the standard for most events with 5 solves. The best (fastest) and worst (slowest) single times are discarded, and the arithmetic mean of the remaining three times is taken. The formula is:

Ao5 = (sum of all 5 times − fastest time − slowest time) / 3

Each time is measured in seconds, and the result is reported in seconds, usually rounded to two decimal places. This trimming removes the influence of a lucky single solve and a single bad mistake, giving a more representative performance.

Mean of 3 (Mo3): Used for events like 3×3×3 Fewest Moves (where the result is in moves, not seconds) and for finals of some events. It is simply the arithmetic mean of three attempts with no trimming:

Mo3 = (time1 + time2 + time3) / 3

Because there is no discard, a single poor solve can ruin a mean of 3, which is why it is considered a harsher format.

Worked Example

Using the default values from the calculator above: 12.45 s, 11.82 s, 13.01 s, 10.97 s, and 12.33 s.

Average of 5:

  1. Find the fastest time: 10.97 s
  2. Find the slowest time: 13.01 s
  3. Sum all five: 12.45 + 11.82 + 13.01 + 10.97 + 12.33 = 60.58 s
  4. Subtract fastest and slowest: 60.58 − 10.97 − 13.01 = 36.60 s
  5. Divide by 3: 36.60 / 3 = 12.20 s

The Ao5 is 12.20 s, matching the calculator’s first output.

Mean of 3: Using only the first three times: (12.45 + 11.82 + 13.01) / 3 = 37.28 / 3 = 12.4266…, which rounds to 12.43 s.

Assumptions

  • All times are valid, non-penalized solves (no +2 second penalties or DNFs are included in this simple calculator).
  • The calculator treats a DNF (Did Not Finish) as a time of infinity, which cannot be averaged; in real WCA results, a DNF is the worst value and is always trimmed in an Ao5, but it cannot be trimmed in a Mo3, making the whole mean a DNF.
  • Times are entered in seconds with decimal places, matching how stopwatches and Stackmat timers record them.
  • No inspection or penalty adjustments are applied; this is purely the arithmetic of the official formats.

How the WCA Formats Actually Work

In official WCA competitions, the format is decided by the event and the round. Most speedcubing events (3×3×3, 2×2×2, 4×4×4, Pyraminx, Skewb, etc.) use a combined format in early rounds: you get two solves, and if your best single is below a cutoff time, you continue to all five solves; otherwise you are done after two. The final round is always a full Average of 5 for these events.

Some events use a Mean of 3 exclusively: 3×3×3 Fewest Moves (measured in moves, not seconds), 3×3×3 Multi-Blind (scored by points, not time alone), and 3×3×3 Blindfolded in some round structures. Clock and Megaminx use Ao5. The key distinction is that Ao5 protects you from one disaster, while Mo3 does not.

When a competitor gets a DNF or a +2 penalty, the arithmetic changes. A +2 adds two seconds to the solve time. A DNF is treated as the worst possible result. In an Ao5, a single DNF is simply the slowest time and gets discarded, so the average can still stand. Two DNFs in an Ao5 mean one DNF remains after trimming, and the average is recorded as DNF. In a Mo3, any single DNF makes the entire mean a DNF.

Common Mistakes When Using a WCA Calculator

  • Confusing Ao5 and Mo3: Entering five times but expecting a mean of 3, or using three times for an average of 5. They are different formulas and different event formats.
  • Forgetting to trim: Manually averaging all five times without removing the best and worst gives a slower, incorrect number. The official result is always the trimmed mean.
  • Rounding too early: If you round each solve to two decimals before averaging, you can be off by a hundredth. WCA results are computed from the full precision of the recorded times, then rounded once at the end.
  • Ignoring penalties: A +2 second penalty must be added to the raw time before the average is computed. A DNF cannot be entered as a number; it is not 0 or 999, it is a separate category.
  • Using a mean for a single round: Some rounds use “Best of 3” or “Best of 2” formats where only the best single solve counts, not an average or mean. A WCA average calculator is not relevant there.

Why the Trimming Rule Exists

The WCA adopted the trimmed average to balance fairness and consistency. Speedcubing has high variance: a single solve can be ruined by a pop, a lock-up, or a bad look-ahead, while another solve might be a personal best due to an easy scramble. If all five solves were averaged, one lucky or unlucky solve would swing the result too much. By discarding the extremes, the Ao5 reflects the competitor’s typical performance rather than their best or worst moment. This is the same logic behind trimmed means in other sports statistics, like Olympic gymnastics scoring, where the highest and lowest judge scores are dropped.

The Mo3 format, by contrast, is used when the attempt count is small (three) and the event is more about consistency under pressure, such as blindfolded solving or fewest moves. There is no room for a mistake, which is exactly the point.

How to Choose the Right Calculator

When you search for a WCA calculator online, you will find several. Look for one that explicitly states whether it computes Ao5 or Mo3, and check if it handles DNF and +2 penalties. A good calculator will let you mark a solve as DNF or add a penalty, because those are common in real competition results. If a calculator only accepts plain numbers, it is fine for practice but incomplete for official results.

Also check whether the calculator rounds correctly. The WCA rounds results to two decimal places (hundredths of a second), but some events like Fewest Moves round to whole moves. A calculator that rounds to three decimals is not following WCA convention.

For practice at home, the exact format matters less, but if you are tracking your progress toward a competition goal, use the same format the competition will use. For example, if you are training for a 3×3×3 final, track your Ao5, not your Mo3.

Limits of the Simple Calculator

The calculator on this page handles the pure arithmetic of the two standard formats. It does not handle:

  • DNF or DNS (Did Not Start) entries, which require special logic.
  • +2 second penalties, which must be added to the raw time before averaging.
  • Combined rounds (cutoff formats) where fewer than 5 solves are done.
  • Multi-Blind scoring, which uses a points formula (solved − unsolved) rather than a time average.
  • Fewest Moves, where the “time” is a move count, not seconds.

For those cases, you need a more specialized tool or the official WCA regulations. The official WCA website publishes the full regulation text, which is the authoritative source for how results are computed.

Frequently Asked Questions

What is the difference between Average of 5 and Mean of 3?
Average of 5 discards the fastest and slowest of five solves, then averages the middle three. Mean of 3 simply averages all three solves with no discards. Ao5 is more forgiving of a single bad solve; Mo3 is not.

Can a DNF be averaged?
In an Average of 5, a single DNF is treated as the worst solve and is discarded, so the average can still be valid. In a Mean of 3, any DNF makes the entire mean a DNF. Two DNFs in an Ao5 also result in a DNF average.

How do I add a +2 second penalty?
Add 2 seconds to the raw solve time before entering it into the calculator. For example, a solve that took 15.32 seconds with a +2 penalty is entered as 17.32 seconds.

Why is my manual average different from the official result?
You likely forgot to trim the best and worst times, or you rounded each solve time before averaging. Use the full times, trim, then round once at the end.

What is a “combined round” cutoff?
In some early rounds, you get two solves. If your best single is below a cutoff time (e.g., 30 seconds), you continue to all five solves. If not, you finish with just two solves and no average is recorded.

Does the WCA use this average for ranking?
Yes. Official rankings list both single and average results. The average is the primary ranking metric for most events, so a good Ao5 is essential for advancing in competitions.

Related

Formula used
in t1 | Solve 1 (seconds) | s | 12.45 | 0
in t2 | Solve 2 (seconds) | s | 11.82 | 0
in t3 | Solve 3 (seconds) | s | 13.01 | 0
in t4 | Solve 4 (seconds) | s | 10.97 | 0
in t5 | Solve 5 (seconds) | s | 12.33 | 0
out avg | Average of 5 (trimmed mean) | s | (t1 + t2 + t3 + t4 + t5 - max(t1,t2,t3,t4,t5) - min(t1,t2,t3,t4,t5)) / 3 | 2
out mean | Mean of 3 (no trim) | s | (t1 + t2 + t3) / 3 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →