molecalculator

Moles & Molar Mass

Liters per Kilometer: Formula and Calculator

Calculator No. 01-6454 · Updated · Formula and assumptions shown below

Fuel consumption 0.0800 L/km
Fuel consumption per 100 km
8.00 L/100 km
= Fuel consumption × 100
Fuel used
8 L
Set in the form below
Distance traveled
100 km
Set in the form below
You enter
Fuel used (L), Distance traveled (km)
You get
Fuel consumption (L/km), Fuel consumption per 100 km (L/100 km)
Rounding
4 dp · 2 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

This calculator works out fuel consumption in liters per kilometer (L/km) from the fuel used and the distance traveled. Enter liters and kilometers to get the consumption rate; a smaller result means less fuel is used per kilometer.

Formula

Liters per kilometer is fuel volume divided by distance:

L/km = liters of fuel ÷ kilometers traveled

In the calculator, l is the fuel used in liters (L), km is the distance traveled in kilometers (km), and lpkm is the resulting rate in liters per kilometer. The second result converts that rate to liters per 100 kilometers: multiply L/km by 100. The calculator expects both inputs to be nonnegative, but distance must be greater than zero to produce a meaningful result.

This is a ratio, not a measure of the vehicle’s fuel tank size or the distance it can travel on one liter. It describes how much fuel was used over a particular distance. For example, 0.08 L/km is equivalent to 8 L/100 km.

Worked Example

Using the calculator’s default values, fuel used is 8 L and distance is 100 km.

  1. Divide fuel volume by distance: 8 L ÷ 100 km = 0.08 L/km.
  2. Convert to liters per 100 kilometers: 0.08 L/km × 100 = 8.00 L/100 km.

The calculator returns 0.0800 L/km and 8.00 L/100 km when displayed to the specified decimal places.

Assumptions

  • The fuel amount and distance refer to the same trip or measurement period.
  • Fuel volume is entered in liters and distance in kilometers; no unit conversion is applied.
  • Distance must be greater than zero. A zero-distance reading cannot produce a consumption rate.
  • The result is an average over the stated distance, not a prediction of future consumption.

What You’ll Need

  • The fuel volume used, measured in liters.
  • The distance traveled over the same period, measured in kilometers.
  • A calculator, spreadsheet, or the calculator above.

For a useful real-world estimate, record fuel and distance consistently. A common approach is to note the odometer at the start, drive, then record the fuel required to restore the tank to the same fill level. Use the distance between readings and the fuel added for that interval. Do not compare an entire trip’s distance with fuel used during only part of it.

Step-by-Step

  1. Choose the measurement period. Decide whether you want consumption for one trip or across several days. The fuel figure and distance figure must cover exactly the same period. For a multi-trip average, add all relevant fuel and distance before dividing.
  2. Find the fuel used. Use a reliable record of fuel consumed, in liters. If you are using a fill-up method, use the amount needed to refill after driving and keep the starting and ending fill levels as similar as practical. Fuel purchased is not always exactly the same as fuel consumed if the tank level changed substantially.
  3. Find the distance traveled. Record the kilometers driven over that same period using an odometer or trip meter. If the distance is provided in miles, convert it first: kilometers = miles × 1.609344. Do not enter a miles figure in the kilometers field.
  4. Enter the two values. Put liters used in the fuel field and kilometers traveled in the distance field. Check decimal separators and units before calculating. For example, enter 8.5 for 8.5 liters, not 8,500 milliliters.
  5. Divide liters by kilometers. Apply L/km = liters ÷ kilometers. If 6 liters were used over 120 km, the calculation is 6 ÷ 120 = 0.05 L/km.
  6. Read the result and, if useful, convert it. The calculator also shows L/100 km, a commonly used comparison format. Multiply L/km by 100; 0.05 L/km becomes 5 L/100 km. Keep the units beside the number so it is not mistaken for km/L.
  7. Repeat measurements for a representative average. A single trip can be affected by traffic, hills, weather, load, and driving style. For a steadier estimate, measure across several comparable fill-up intervals and calculate total liters divided by total kilometers. Avoid averaging individual rates without considering the different distances covered.

Common Mistakes

  • Reversing the division. Liters per kilometer is liters ÷ kilometers. Dividing kilometers by liters gives kilometers per liter (km/L), a different measure where a larger number generally indicates better fuel economy.
  • Mixing units. The formula requires liters and kilometers. Convert gallons to liters (1 US gallon = 3.785411784 L; 1 Imperial gallon = 4.54609 L) and miles to kilometers before calculating. US and Imperial gallons are not interchangeable.
  • Using mismatched periods. If the fuel amount covers several trips but the distance covers only one, the answer will be misleading. Match the start and end points for both measurements.
  • Treating fuel purchased as exact fuel consumed. A partial refill may leave the tank at a different level. For improved accuracy, compare consistent full-to-full intervals or aggregate several refills and distances.
  • Rounding too early. Keep the original readings through the calculation and round only the final result. Small rates such as 0.04 L/km can look like zero if rounded too aggressively.
  • Comparing different formats directly. L/km, L/100 km, and km/L express fuel economy differently. Convert the values to one common unit before comparing vehicles or records.

Tips

  • Use the trip meter or record odometer readings at every fill-up, along with the liters added and date.
  • For multiple intervals, calculate total liters ÷ total kilometers. This distance-weighted result is more appropriate than taking a plain average of separate L/km readings.
  • Keep more decimal places during calculations, then report a practical rounded value such as 0.075 L/km or 7.5 L/100 km.
  • Use the same fuel-volume unit, distance unit, and measurement method whenever you compare results.
  • For quick interpretation, multiply L/km by 100 to get L/100 km. To convert L/km to km/L, use 1 ÷ (L/km), provided the rate is above zero.

Troubleshooting

The calculator shows an error or no result: check that both entries are numbers, that fuel and distance are not negative, and that distance is greater than zero. A zero or blank distance cannot be used as the divisor.

The result seems far too high: check whether you entered miles instead of kilometers, milliliters instead of liters, or a fuel amount from a longer period than the distance. Also check whether a comma or decimal point was interpreted as intended.

The result seems implausibly low: verify that the fuel figure is the amount consumed rather than a small top-up, and that the distance is in kilometers rather than miles. Confirm that you have not accidentally calculated km/L and labeled it L/km.

Repeated readings vary substantially: use more than one fill-up interval and compare similar conditions. Uneven tank filling, short trips, traffic, terrain, temperature, and vehicle load can all affect measured consumption. If the difference is persistent or the vehicle’s behavior has changed suddenly, check the vehicle’s maintenance guidance or seek a qualified inspection.

Frequently Asked Questions

How do you calculate liters per kilometer?
Divide the liters of fuel used by the kilometers traveled. For example, 5 L ÷ 100 km = 0.05 L/km.

How do I convert L/km to L/100 km?
Multiply L/km by 100. A rate of 0.07 L/km is 7 L/100 km.

Is a lower L/km value better?
Generally, yes: it means less fuel was used for each kilometer. Comparisons are most useful when measurements use the same method and similar driving conditions.

What is the difference between L/km and km/L?
L/km is fuel used per distance, so lower is generally better. Km/L is distance traveled per fuel volume, so higher is generally better. They are reciprocals: km/L = 1 ÷ (L/km).

Can I calculate L/km from miles and gallons?
Yes, but convert first. Convert miles to kilometers and gallons to liters, then divide liters by kilometers. Identify whether the gallons are US or Imperial gallons.

Can I use this calculation to predict my next trip’s fuel use?
You can make a rough estimate by multiplying the rate by the planned kilometers, but actual consumption may differ with route, traffic, weather, load, and driving conditions.

Related

Formula used
in l | Fuel used | L | 8 | 0
in km | Distance traveled | km | 100 | 0
out lpkm | Fuel consumption | L/km | l / km | 4
out lp100 | Fuel consumption per 100 km | L/100 km | lpkm * 100 | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →