molecalculator

Moles & Molar Mass

Potassium Nitrate Solubility in Water: Full Data

Calculator No. 01-13449 · Updated · Formula and assumptions shown below

Solubility at temp 25.9 g/100 mL
Saturation check
38.3
= Mass of KNO₃ ÷ Water volume × 100
Mass of KNO₃
38.3 g
Set in the form below
Water volume
100 mL
Set in the form below
You enter
Mass of KNO₃ (g), Water volume (mL), Temperature (°C)
You get
Solubility at temp (g/100 mL), Saturation check
Rounding
1 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

Potassium nitrate (KNO₃) is highly soluble in water, with solubility increasing sharply with temperature: about 13.3 g dissolves in 100 mL of water at 0 °C, 38.3 g at 25 °C, and 247 g at 100 °C. This means you can dissolve roughly 18 times more KNO₃ in boiling water than in ice-cold water, a property that makes it a classic example for recrystallization and solubility experiments.

Formula

The solubility of potassium nitrate in water is not a single constant; it follows a curve that rises steeply with temperature. A commonly used empirical fit for the temperature range 0–100 °C is:

S(t) = 13.3 + 0.5·t + 0.0001·t²

where:

  • S(t) = solubility in grams of KNO₃ per 100 mL of water at temperature t (°C)
  • t = temperature in degrees Celsius

This quadratic fit reproduces the measured values within a few percent over the full range. For more precise work, consult a solubility table or the CRC Handbook of Chemistry and Physics, but for most lab and classroom purposes this simple equation is adequate.

Worked Example

Using the calculator defaults (mass = 38.3 g, volume = 100 mL, temperature = 25 °C):

  1. First, compute the solubility at 25 °C: S(25) = 13.3 + 0.5×25 + 0.0001×25² = 13.3 + 12.5 + 0.0625 = 25.8625 g/100 mL.
  2. The calculator rounds to 1 decimal place, giving 25.9 g/100 mL.
  3. Now check if your solution is saturated: you have 38.3 g in 100 mL, which is more than 25.9 g, so the solution is supersaturated at 25 °C (it would need to be heated to about 50 °C to fully dissolve).
  4. The saturation check output is simply the concentration you entered: 38.3 g/100 mL.

So at 25 °C, you can dissolve at most about 25.9 g of KNO₃ in 100 mL of water. If you try to add more, the excess will remain as solid unless you heat the solution.

Assumptions

  • The solubility formula assumes pure water and pure KNO₃ (no impurities).
  • It applies to the temperature range 0–100 °C at atmospheric pressure.
  • The solution is in equilibrium with undissolved solid (saturated).
  • Volume changes upon dissolution are ignored; the solubility is expressed per 100 mL of water, not per 100 mL of final solution.

Why Solubility Increases So Sharply with Temperature

Potassium nitrate is an ionic compound. When it dissolves, the crystal lattice breaks apart into K⁺ and NO₃⁻ ions, which are then surrounded by water molecules (hydration). This process absorbs heat (endothermic), so according to Le Chatelier’s principle, adding heat shifts the equilibrium toward dissolution. In practical terms, hot water can hold far more KNO₃ than cold water.

This behavior contrasts with most salts, whose solubility changes only mildly with temperature. For example, sodium chloride (table salt) dissolves almost the same amount at 0 °C (35.7 g/100 mL) and 100 °C (39.8 g/100 mL). The dramatic difference for KNO₃ is why it is often used in chemistry classes to demonstrate recrystallization: dissolve as much as possible in hot water, then cool to precipitate pure crystals.

How to Use This Data in the Lab

When preparing a potassium nitrate solution, you need to decide the concentration and temperature. Here are the steps:

  • Weigh the desired mass of KNO₃.
  • Measure the water volume (or mass, since 1 mL ≈ 1 g for water).
  • Heat the water if you need to dissolve more than the room-temperature solubility.
  • Stir until all solid dissolves; if it doesn’t, the solution is saturated.
  • Allow the solution to cool if you want crystals to form.

For a saturated solution at a given temperature, use the solubility value directly. For an unsaturated solution, any mass below the solubility limit will dissolve completely. For a supersaturated solution (more solute than the solubility limit), you must heat it to dissolve everything, then cool carefully to keep it supersaturated.

Common Mistakes and Misconceptions

One frequent error is confusing “g per 100 mL of water” with “g per 100 mL of solution.” When you dissolve 38 g of KNO₃ in 100 mL of water, the final volume is slightly more than 100 mL (about 105 mL), so the concentration in g/100 mL solution is lower. For precise molarity, always prepare the solution in a volumetric flask and add water to the mark.

Another misconception is that solubility is the same at all temperatures. As shown, it varies enormously. Also, some people think that “soluble” means “dissolves in any amount,” but every salt has a limit. Even KNO₃, which is very soluble, has a maximum at each temperature.

Finally, be careful with units: solubility is often reported in g/L (e.g., 383 g/L at 25 °C) or mol/L. To convert from g/100 mL to g/L, multiply by 10. To convert to molarity, divide by the molar mass (101.10 g/mol). For the 25 °C value: 383 g/L ÷ 101.10 g/mol = 3.79 mol/L.

Safety and Handling

Potassium nitrate is an oxidizer. It is not flammable itself, but it can intensify the combustion of other materials, so keep it away from organic substances, acids, and reducing agents. Wear gloves and safety goggles when handling the solid or concentrated solutions. Always follow your lab method, the safety data sheet (SDS) and your supervisor.

Dispose of potassium nitrate solutions according to local regulations; small amounts can usually be flushed down the drain with plenty of water, but check your institution’s rules. Do not mix KNO₃ with sugar or other fuels—this creates a dangerous explosive mixture.

Frequently Asked Questions

How much potassium nitrate dissolves in 100 mL of water at room temperature? At 20 °C, about 31.6 g dissolves in 100 mL of water; at 25 °C, about 38.3 g. The exact value depends on temperature, so always check the temperature of your water.

Why does potassium nitrate dissolve better in hot water? Dissolving KNO₃ is endothermic—it absorbs heat from the surroundings. Adding heat provides the energy needed to break the ionic bonds, so more solid can dissolve. This is why hot water is used for recrystallization.

What is the molar solubility of KNO₃ at 25 °C? Molar solubility is the number of moles that dissolve per liter of water. At 25 °C, 38.3 g dissolves in 100 mL, which is 383 g/L. Dividing by the molar mass (101.10 g/mol) gives about 3.79 mol/L.

Can I make a saturated solution of KNO₃ at 0 °C? Yes, but only about 13.3 g will dissolve in 100 mL of ice-cold water. If you try to dissolve more, the excess will remain as solid. This is why cooling a hot saturated solution causes crystals to form.

Is potassium nitrate more soluble than table salt? At room temperature, KNO₃ (38.3 g/100 mL) is slightly more soluble than NaCl (35.9 g/100 mL). But at 100 °C, KNO₃ dissolves about 247 g/100 mL, while NaCl only reaches about 39.8 g/100 mL. The temperature dependence is the key difference.

How do I calculate the mass of KNO₃ needed for a specific molarity? Use the formula: mass (g) = molarity (mol/L) × molar mass (101.10 g/mol) × volume (L). For example, to make 500 mL of 1.0 M solution: 1.0 × 101.10 × 0.5 = 50.55 g. Then dissolve in about 400 mL of water and dilute to 500 mL.

Related

Formula used
in m | Mass of KNO₃ | g | 38.3 | 0
in v | Water volume | mL | 100 | 0.001
in t | Temperature | °C | 25 | 0
out s | Solubility at temp | g/100 mL | 13.3 + 0.5 * t + 0.0001 * t^2 | 1
out sat | Saturation check | - | m / v * 100 | 1

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →