molecalculator

Moles & Molar Mass

NH Excess Wage Calculator: How to Use It

Calculator No. 01-13010 · Updated · Formula and assumptions shown below

The calculator on this page is switched off while it is checked. The formula is below, and the worked example shows how to do the sum by hand.

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

The NH Excess Wage Calculator works out the amount of an employee’s weekly wage that exceeds the New Hampshire average weekly wage, which is the basis for calculating partial unemployment benefits in New Hampshire. You enter the employee’s gross weekly wage and the current state average weekly wage, and the calculator returns the excess wage amount that reduces their weekly benefit amount. This figure is essential for employers and claimants to understand how part-time earnings affect unemployment compensation.

Formula

The excess wage is simply the employee’s gross weekly wage minus the New Hampshire average weekly wage:

Excess Wage = Employee’s Gross Weekly Wage − NH Average Weekly Wage

  • Employee’s gross weekly wage (in dollars): the total earnings from all employment for that week, before any deductions.
  • NH average weekly wage (in dollars): the statewide average weekly wage as determined by New Hampshire Employment Security (NHES) for the relevant calendar year.

If the result is negative, it means the employee’s wage is below the state average, so there is no excess wage; the excess is treated as zero for benefit calculations.

Worked Example

Using the default values from the calculator: an employee earns a gross weekly wage of $500, and the NH average weekly wage is $1,500.

  1. Start with the employee’s gross weekly wage: $500
  2. Subtract the NH average weekly wage: $500 − $1,500 = −$1,000
  3. Since the result is negative, the excess wage is $0 (not −$1,000).

The calculator shows an excess of $0.00, because a negative excess is not used in the partial benefit formula. In practice, if the employee earns more than the average weekly wage, the excess is that positive difference.

Assumptions

  • The employee’s gross weekly wage is the total earnings before taxes or other deductions.
  • The NH average weekly wage is the official value published by NHES for the applicable year.
  • Only wages from employment are considered; self-employment income may be treated differently.
  • The formula assumes a single-week calculation; partial benefits are computed on a weekly basis.

How Partial Unemployment Benefits Work in New Hampshire

In New Hampshire, when an unemployed worker earns some money during a week, their weekly benefit amount (WBA) is reduced by the amount of wages that exceed a certain threshold. The threshold is typically 1.3 times the weekly benefit amount, but the excess wage calculation is a separate concept used to determine the reduction. Specifically, NH law (RSA 282-A:25) states that if an individual earns wages in excess of the average weekly wage, that excess is deducted from their weekly benefit. For example, if the state average weekly wage is $1,500 and a claimant earns $1,800 in a week, the excess is $300; that $300 is subtracted from their WBA, potentially reducing it to zero if the WBA is less than $300.

Why the Average Weekly Wage Matters

The New Hampshire average weekly wage is recalculated annually by NHES based on statewide earnings data. It is used not only for partial benefit calculations but also for determining the maximum weekly benefit amount and the taxable wage base. For 2024, the average weekly wage was approximately $1,500 (you should check the current NHES publication for the exact figure). Knowing this number is critical because it directly affects how much a claimant can earn before their benefits are reduced.

Common Mistakes and Misconceptions

  • Using net pay instead of gross pay: The excess wage calculation uses gross earnings, not take-home pay.
  • Confusing the excess wage with the earnings disregard: Some states allow a small earnings disregard (e.g., the first $50), but New Hampshire’s partial benefit rule is based on the excess over the average weekly wage, not a fixed disregard.
  • Assuming the average weekly wage is the same for all years: It changes annually; using an outdated figure will give wrong results.
  • Forgetting that self-employment income counts: If a claimant does freelance work, that income is generally included in gross weekly wages.

How to Find the Current NH Average Weekly Wage

The official source is the New Hampshire Employment Security (NHES) website, which publishes the average weekly wage in its annual financial reports or in the unemployment insurance handbook. You can also contact NHES directly. As of this writing, the most recent figure is around $1,500, but always verify with the official source for the year you are calculating.

Frequently Asked Questions

What is the NH excess wage calculator used for?

It calculates the amount by which an employee’s weekly earnings exceed the New Hampshire average weekly wage. This excess is deducted from the weekly unemployment benefit amount, so it helps claimants and employers estimate how much a person will receive in partial benefits.

What if my weekly wage is less than the average weekly wage?

Then the excess wage is zero, and your earnings may not reduce your benefit (subject to other rules). In the calculator, a negative result is shown as $0.00 because a negative excess has no meaning in the benefit formula.

Does the calculator include the weekly benefit amount?

No, it only computes the excess wage. To get the actual partial benefit, you would subtract the excess from your weekly benefit amount (WBA), but the WBA depends on your earnings history and is determined by NHES.

Is the NH average weekly wage the same as the federal average?

No, each state calculates its own average weekly wage. New Hampshire’s figure is specific to its workforce and is used only for its unemployment insurance program.

Can I use this calculator for any state?

No, the formula is specific to New Hampshire’s partial benefit rule. Other states have different methods, often using a percentage of the weekly benefit amount as the earnings disregard.

Where can I get the official NH average weekly wage?

From the New Hampshire Employment Security website or by contacting their unemployment insurance division. The figure is updated annually, so always use the current year’s value.

Related

Formula used
in m | Employee's gross weekly wage | $ | 500 | 0
in aww | NH average weekly wage | $ | 1500 | 0
out excess | Excess wage | $ | m - aww | 2

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →