molecalculator

Moles & Molar Mass

CCF to Liters: Liquid Nitrogen Conversion

Calculator No. 01-7216 · Updated · Formula and assumptions shown below

Volume in liters 2,831.68 L
Volume in gallons (US)
748.1 gal
= Volume in CCF × 748.052
Volume in CCF
1 CCF
Set in the form below
You enter
Volume in CCF (CCF)
You get
Volume in liters (L), Volume in gallons (US) (gal)
Rounding
2 dp · 1 dp

For study and lab planning. The result follows from the numbers you enter and the formula shown. Check it against your method before you weigh, mix or dilute anything, follow the safety data sheet and your supervisor, and do not use it for clinical, dosing or medication work.

One hundred cubic feet (CCF) of liquid nitrogen equals 2,831.68 liters. This conversion is exact for any liquid: 1 CCF = 100 cubic feet, and 1 cubic foot = 28.316846592 liters, so multiplying 100 by 28.316846592 gives 2,831.6846592 liters. Below, we explain the conversion in detail, compare liquid nitrogen to its gaseous form, and cover practical considerations for storage and use.

Formula

The conversion is straightforward: Liters = CCF × 2,831.6846592.

Where:

  • CCF = volume in hundred cubic feet (1 CCF = 100 ft³)
  • Liters = volume in liters (L)
  • 2,831.6846592 = number of liters in 100 cubic feet (exact conversion factor: 1 ft³ = 28.316846592 L)

For US gallons, multiply CCF by 748.052 (since 1 ft³ = 7.48052 gal).

Worked Example

Using the default value of 1 CCF:

  1. Start with 1 CCF.
  2. Convert CCF to cubic feet: 1 CCF × 100 = 100 ft³.
  3. Convert cubic feet to liters: 100 ft³ × 28.316846592 L/ft³ = 2,831.6846592 L.
  4. Round to 2 decimals: 2,831.68 L.

For gallons: 1 CCF × 748.052 = 748.05 US gallons.

Assumptions

  • The conversion is purely volumetric; it holds for any liquid, including liquid nitrogen, at any temperature and pressure.
  • No correction for thermal expansion is needed because the conversion factor is based on the definition of the foot and liter, not on the substance.
  • US gallons are used (not imperial gallons).

Liquid Nitrogen vs. Nitrogen Gas: The Expansion Factor

Liquid nitrogen boils at -196°C (-321°F) at atmospheric pressure. When it vaporizes, it expands dramatically. One liter of liquid nitrogen produces approximately 0.682 cubic meters (682 liters) of nitrogen gas at standard temperature and pressure (0°C, 1 atm). This expansion ratio is roughly 1:682. Therefore, 1 CCF (2,831.68 L) of liquid nitrogen would vaporize to about 1,932 cubic meters of gas. This is why liquid nitrogen is used for efficient storage and transport of nitrogen—it takes up far less space than the gas.

Why Use CCF for Liquid Nitrogen?

CCF (hundred cubic feet) is a common billing unit for natural gas in the United States, but it also appears in industrial gas contexts, especially when quoting bulk liquid nitrogen deliveries. Suppliers may quote prices per CCF or per liter, depending on the customer and region. Understanding the conversion helps you compare quotes, estimate tank capacity, and plan usage. For example, a typical liquid nitrogen storage dewar might hold 50 liters (about 0.0177 CCF). A large bulk tank on a hospital campus might hold 3,000 gallons (about 4.01 CCF).

How to Choose the Right Unit for Your Needs

When working with liquid nitrogen, you’ll encounter several units: liters, gallons, cubic feet, and sometimes pounds or kilograms. Here’s how to choose:

  • Liters – Most common for laboratory dewars and small-scale use. Easy to measure with a dipstick or scale.
  • Gallons (US) – Used in industrial settings, especially in the US. 1 gallon = 3.78541 L.
  • Cubic feet (CCF) – Used for bulk gas billing and sometimes for cryogenic storage tanks.
  • Pounds or kilograms – Useful when weight matters, e.g., for shipping or structural support. Liquid nitrogen density is about 0.807 kg/L at its boiling point, so 1 L weighs about 0.807 kg (1.78 lb).

Always confirm which gallon (US or imperial) is being used in a quote. Imperial gallons are about 20% larger than US gallons.

Common Problems and Misconceptions

One common mistake is confusing CCF with CF (cubic feet). CCF is 100 cubic feet, so a 10 CCF tank is 1,000 cubic feet, not 10. Another issue is mixing up liquid and gas volumes. A supplier might quote “1,000 cubic feet of nitrogen” meaning gas, not liquid. Always clarify whether the volume is liquid or gas. Also, remember that liquid nitrogen is not water; its density changes with temperature, but the volume conversion (CCF to liters) is independent of density because it’s a pure geometric conversion.

Another misconception: “1 CCF of liquid nitrogen equals 100 cubic feet of gas.” That’s false. As noted, 1 CCF of liquid produces roughly 1,932 cubic feet of gas (at STP). The expansion ratio is about 682, so 100 ft³ of liquid → 68,200 ft³ of gas.

Costs and Practical Considerations

Liquid nitrogen is typically sold by the liter or by the pound. Prices vary widely by region, purity, and quantity. As of recent years, bulk liquid nitrogen might cost around $0.20 to $0.50 per liter, but this is not a fixed figure. When comparing prices, convert everything to a common unit. For example, if one supplier quotes $0.30/L and another quotes $0.85/CCF, the second is $0.85/2,831.68 L = $0.0003/L, which is absurdly low—likely a gas quote, not liquid. Always verify the phase.

Storage costs include the dewar rental or purchase, and evaporation losses (boil-off). A typical dewar loses 1-3% of its volume per day, depending on insulation. Over a month, a 50 L dewar might lose 15-45 L. This is why large users prefer bulk tanks with lower surface-area-to-volume ratios.

Safety and Handling

Liquid nitrogen is extremely cold and can cause severe frostbite or cryogenic burns on contact. It also displaces oxygen, creating an asphyxiation hazard in enclosed spaces. Always handle it with proper personal protective equipment: insulated gloves, face shield, and long sleeves. Use only approved cryogenic containers that are vented to prevent pressure buildup. Never seal a container completely, as the expanding gas can cause an explosion. When working in a lab, follow your lab method, the safety data sheet (SDS) and your supervisor.

Frequently Asked Questions

How many liters are in 1 CCF of liquid nitrogen?

Exactly 2,831.68 liters (rounded to two decimals). This is because 1 CCF = 100 cubic feet and 1 cubic foot = 28.316846592 liters.

How many gallons are in 1 CCF?

There are 748.05 US gallons in 1 CCF. If you are using imperial gallons, it would be about 622.88 imperial gallons (since 1 imperial gallon = 4.54609 L).

How much does 1 CCF of liquid nitrogen weigh?

Using the density of liquid nitrogen at its boiling point (about 0.807 kg/L), 1 CCF (2,831.68 L) weighs about 2,285 kg (5,038 lbs). However, density varies slightly with temperature and pressure, so this is approximate.

Can I convert CCF directly to cubic meters?

Yes. 1 CCF = 100 ft³ = 2.83168 m³ (since 1 ft = 0.3048 m, so 1 ft³ = 0.0283168 m³). For liquid nitrogen, this is the same as for any liquid.

Why do some suppliers quote liquid nitrogen in CCF instead of liters?

CCF is a legacy unit used in the gas industry, especially for natural gas billing. Some industrial gas suppliers continue to use it for bulk liquid nitrogen because it aligns with their existing accounting systems. It’s not a scientific standard, but you’ll encounter it in commercial transactions.

Is the conversion different for liquid nitrogen vs. liquid oxygen?

No. The CCF-to-liters conversion is a pure volume conversion and is identical for any liquid. However, the weight and gas expansion ratio differ because densities and molecular weights differ.

Related

Formula used
in v | Volume in CCF | CCF | 1 | 0 | 1000
out l | Volume in liters | L | v * 2831.6846592 | 2
out g | Volume in gallons (US) | gal | v * 748.052 | 1

Each line is one input (in, sel, list) or one result (out: label, unit, formula, decimals). How the calculators work

Method: the standard formula for this calculation with the constants and conversion factors written on the page, rounded as each result states. See method and constants, the disclaimer or report an error.

More in this section

The whole Moles & Molar Mass section →